3M X95 - Digital Projector XGA LCD Handleiding productveiligheid - Pagina 14
Blader online of download pdf Handleiding productveiligheid voor {categorie_naam} 3M X95 - Digital Projector XGA LCD. 3M X95 - Digital Projector XGA LCD 18 pagina's. 3m digital projector x95
Ook voor 3M X95 - Digital Projector XGA LCD: Snelle installatie (1 pagina's)
Pagina afdrukken
Replacing the internal clock battery
Consumption of the battery makes the clock not to work correctly. When the clock is wrong or it
has stopped, please replace the battery according to the following procedures.
1. Turn the projector off, and unplug the power cord. Allow the projector
2. After making sure that the projector has cooled adequately, slowly
turn over the projector, so that the bottom is facing.
3. Remove the battery cover.
Turn the battery cover in the direction indicated "OPEN" using such
as coins. Then the battery cover will come up. While removing the
battery cover, pick its knob.
4. Take the old battery out.
Press the metal claw of the battery holder. Then the battery will come
up. Remove the battery.
5. Put a new battery in.
Replace battery with HITACHI MAXELL, Part No.CR2032 only.
Insert a new battery in the battery holder according to its minus
terminal – as indicated in the battery holder, so that the side marked
6. Close the battery cover.
Replace the battery cover in place, then turn it in the direction
•
Always handle the batteries with care and use them only as directed. Battery may
or pollution of the surrounding environment.:
-
-
Make sure the plus and minus terminals are correctly aligned when loading a battery.
If the battery is placed in the battery holder upside-down, it may be hard to remove.
-
Keep a battery away from children and pets. If swallowed consult a physician
immediately for emergency treatment.
-
Do not short circuit or solder a battery.
-
-
If you observe battery leakage, wipe out the leakage and then replace a battery. If the
leakage adheres to your body or clothes, rinse well with water immediately.
-
Obey the local laws on disposing the battery.
If the battery is placed in the battery holder upside-down, follow the procedure below to
remove and reload it properly.
1. Remove the battery cover as described in steps 1 through 3 above.
2. Turn the projector over again, so that the top of the projector is facing up.
3. While lifting the side of the projector closest to the lens, press the metal claw of the battery holder.
The battery will fall out of the holder, so be careful not to lose it.
4. Turn the projector over once more, so that the bottom faces up, and reload the battery correctly.
time via the menu or a web browser after replacing the battery.
(
Date/Time Settings in the Network Guide)
14
WARNING
Note
3M™ Digital Projector X95 Product Safety Guide
Battery Cover
Knob
Metal claw
"+" marking
© 3M 2007