FLENDER FASTEX IC230 Montage- en bedieningshandleiding - Pagina 10

Blader online of download pdf Montage- en bedieningshandleiding voor {categorie_naam} FLENDER FASTEX IC230. FLENDER FASTEX IC230 15 pagina's.

4.1 Assembling the clamping element

The design torque T

ensured that the cylinder head bolts are tightened with the tightening torques

according to Table 7-1

Preparatory work

1. Make sure the surfaces to be joined are in perfect condition.

2. Clean the contact surfaces as well as the shaft and hub.

3. Slightly oil the contact surfaces. Do not use any grease or oil that contains molybdenum

4. Place the clamping bush (2) on the clamping hub (1). Position the clamping bush (2) so

5. Screw the clamping hub (1) to the clamping bush (2) without tightening the cylinder-head

Assemble

1. Position the pre-assembled clamping element in the hub bore and then place both parts

2. Slightly tighten the cylinder-head screws (3) so that the clamping element can still be

3. Align the Clamping element on the shaft.

4. The shaft must fill the entire length of the clamping hub (1).

5. Tighten the cylinder-head screws (3) crosswise in several turns. The specified tightening

FASTEX IC230 Clamping element 3906de

Compact assembly and operating instructions 05/2022

WARNING

must not be exceeded at any operating point. It must be

C l

disulfide or other additives that significantly reduce the coefficient of friction.

that the release threads are offset to the slot in the clamping hub (1).

screws (3).

on the shaft.

moved.

torque can be found in the Tightening torques and widths A/F section.