DOD TEC4X Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DOD TEC4X. DOD TEC4X 8 pagina's. Multi-effects
Ook voor DOD TEC4X: Gebruikershandleiding (8 pagina's)

Pagina afdrukken

FUNCTIONS

SELECTING PROGRAMS

Use either the foot switches (1), or the Up/Down buttons (8). The first three foot switches select programs

and the last foot switch selects banks. To select a specific bank, step on the bank foot switch repeatedly until

the desired bank number appears in LED display (5). Then step on foot switch 1-3 to activate program in

that bank. Only User programs can be selected with the bank foot switch. To select the Factory programs

you must use the Up/Down buttons (8). From the factory, Factory programs are duplicated in all the User

locations.

EDITING PROGRAMS

Editing programs on the TEC4 has been designed to be efficient and simple. To bypass a currently active

effect, press the Effect Selector button (4) twice. The LED display will read "--", indicating the effect is

bypassed. You can also turn a bypassed effect on using the same operation. To change an effect or its setting,

press the Effect Selector button (4). This selects the effect to edit. The currently selected effect number will

appear in the LED Display (5). Use the Up/Down buttons (8) to move up or down through the effects and

effect settings. The Store LED will light indicating that you have made changes to the current program. When

the desired effect or setting has been found, you can save your changes by pressing the Store Button (7).

When the Store Button (7) has been pressed, the LED display will begin to flash (6). This is the TEC4 asking

where you would like to save the program. Use the Up/Down Buttons (8) to select desired program number

and press the Store Button (7) one more time to save. The TEC4X provides 30 User program locations for

you to fill with programs of your own. You can also copy a program to a new location by pressing the Store

Button (7) once and using the Up/Down Buttons (8) to select a new User program location and then

pressing the Store Button (7) again.

BYPASSING

To bypass the current program, press the foot switch (1) of the program you are currently using . "bp" will

appear in the LED display (5). To exit program bypass, press any foot switch.

TUNER ACTIVATION

To activate tuner, press and hold the foot switch (1) of the program you are currently using for approximately

2 seconds. "tu" will appear in the LED display (5). To tune, pluck a string repeatedly (a harmonic at the

12th fret is sometimes works best). The LED Display will show the note being tuned while the the second

vertical row of Effect LEDs will show the tuning status of the note. The note is in tune when the green LED

is lit. LEDs lit above the green LED indicate the note is sharp. LEDs lit below the green LED indicate the note

is flat.

FACTORY RESET

Caution, this procedure will restore all User programs in the TEC4X to factory condition.

All User programs will be erased. To factory reset the TEC4X, press and hold both the Compressor

and Reverb buttons while powering up the TEC4. The display will read "rS". The TEC4 has now restored

all programs to factory condition.