DOD SR835 Gebruikershandleiding - Pagina 6

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DOD SR835. DOD SR835 12 pagina's. Dod stereo equalizers owner's manual sr835

Pagina afdrukken

SR835 Crossover

INSTALLATION

Install the crossover in a rack with the provided rack screws. Route the AC

power cord to a convenient power outlet away from audio lines. The unit may

be turned on and off using the front panel power switch. Since the units draw a

relatively small amount of current during idle, they can be left on continuously.

DOD crossovers generate very little heat during operation and thus do not

need to be specially ventilated or cooled. The units should not, however, be sub-

jected to high temperatures for extended periods. Although the unit's chassis is

shielded against radio frequency and electromagnetic interference, extremely

high RF and EMI fields should be avoided.

ATTENTION: Use only one Channel output connector for each frequency

range at a time. Using the balanced and unbalanced outputs for the same fre-

quency range at the same time can unbalance balanced lines, cause phase can-

cellation, short a conductor to ground, or cause damage to other equipment

connected to the crossover.

FOR BALANCED 1/4 " TRS PHONE PLUG CONNECTION - Wire the con-

nectors as follows:

Phone Plug

tip

ring

sleeve

FOR 1/4" MONO PHONE PLUG CONNECTION:

Phone Plug

tip

sleeve

Once the crossover has been installed and adjusted for the required cross fre-

quencies, and levels, an optional security panel can be installed to keep unautho-

rized persons from changing settings.

Connection

: high

: low

: ground

Connection

: high

: ground