Clinton 85100 Bediening, verzorging en onderhoud - Pagina 4

Blader online of download pdf Bediening, verzorging en onderhoud voor {categorie_naam} Clinton 85100. Clinton 85100 8 pagina's. Power imaging tables

ADJUSTMENTS

(continued)

BACKREST CYLINDER REPLACEMENT (models 85200, 85300 & 85309 only)

The backrest cylinder is replaceable in the field by following these simple directions below.

Tab

Cylinder Pin

Remove cotter pin. Then remove

the slide-out pin. Position tab locat-

ed on the adjustment bar against

cylinder pin.

STIRRUPS (model 85309 only)

Stirrups are shown in the stored position in photo below at left. When extended, stirrups have two width

positions. Position 1 is the narrowest and Position 2 the widest. The length of the stirrups can be adjusted by

moving the stirrup slider to the desired location. When the patient applies foot pressure to the stirrup, it will

automatically lock into position. To return the stirrups to the stored position, fold the stirrup over onto the

slider bar and slide BOTH towards the head end of the table. The stirrup will store under the upholstered top.

Stirrups in the stored position

Align holes in cylinder bracket with holes in table bracket by adjusting

the angle until the holes line up. Install slide-out pin through holes and

replace cotter pin.

Stirrup

Slider

Stirrup positions

Finished view of cylinder assembly.

Stirrup Position 1

Stirrup Position 2