Clinton Electronics CE-M32A-PIR Handleiding basisinstellingen - Pagina 7
Blader online of download pdf Handleiding basisinstellingen voor {categorie_naam} Clinton Electronics CE-M32A-PIR. Clinton Electronics CE-M32A-PIR 9 pagina's. Pvms w/ axis m3065
Ook voor Clinton Electronics CE-M32A-PIR: Handleiding basisinstellingen (7 pagina's)
Pagina afdrukken
Resetting the AXIS M3065 Camera 21"~43" models
Reset to factory default should be used with caution. A reset to factory default will reset all camera settings,
including the IP address, to the factory default values.
Remove 2 screws
on bottom of PVM
Disconnect power from the PVM.
1
To access the camera, remove the 2 door screws located on the bottom of the PVM. Keep these screws in a safe
2
place to close the access door when fi nished.
Press and hold the control button and reconnect power. The control button is nearest the camera. (keep
3
holding the control button down while reconnecting power)
Continue holding the control button until the LED on the camera board starts fl ashing Green/Red. (approx 15-
4
30 seconds). Release the button then close and secure the camera access door.
Color bars will be displayed during the reset. If using the fi rmware that shipped with the camera, the
camera image will return once the reset has fi nished and no additional setup is required. See next page
if the camera fi rmware has been updated.
Basic Setup Guide: "A-Series" PVMs w/ AXIS 3065 Camera
11.21.22
TOP of PVM
LED
microSD
camera
Information in this document is subject to change without notice.
7
Press/Hold Button
Closest to Camera
(Control Button)