Dodge TA5215H Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dodge TA5215H. Dodge TA5215H 4 pagina's. Speed reducer tapered and short shaft bushing assemblies

Pagina afdrukken
Dodge TA5215H Gebruiksaanwijzing
Bushing Removal for Standard Taper or Short Shaft
Bushings
1.
Remove bushing screws.
2.
Place the screws in the threaded holes provided in the
bushing flanges. Tighten the screws alternately and evenly
until the bushings are free on the shaft. For ease of tightening
screws make sure screw threads and thread holes in the
bushing flanges are clean. If the reducer was positioned
closer than the recommended minimum distance "A" as
shown in Table 1, loosen the inboard bushing screws until
they are clear of the bushing flange by 1/8". Locate two (2)
wedges at 180 degrees between the bushing flange and
the bushing backup plate. Drive the wedges alternately and
evenly until the bushing is free on the shaft.
3.
Remove the outside bushing, the reducer, and then the
inboard bushing.
Table 1 - Minimum Required Shaft Length (Inches)
Reducer Size
Standard Taper Bushing
TA0107L
TA1107H
TA2115H
TA3203H
TA4207H
TA5215H
TA6307H
TA7315H
TA8407H
TA9415H
TA10507H
TA12608H
Bushing Screw Information and Minimum Clearance for Removal
Reducer Size
Fastener Size
TA0107L
5/16–18
TA1107H
5/16–18
TA2115H
3/8–16
TA3203H
3/8–16
TA4207H
3/8–16
TA5215H
1/2–13
TA6307H
1/2–13
TA7315H
1/2–13
TA8407H
1/2–13
TA9415H
5/8–11
TA10507H
5/8–11
TA12608H
5/8–11
3
Short Shaft Bushing
6.83
4.32
6.95
4.43
7.80
4.80
8.55
5.46
8.94
5.66
10.33
6.35
10.82
6.72
11.87
7.62
12.82
8.10
13.74
8.56
15.46
9.67
18.32
11.60
Torque in Ft. -Lbs.
A (inches)
17–20
17–20
17–20
17–20
23–26
67–77
67–77
67–77
67–77
75–86
75–86
75–86
1.08
1.20
1.20
1.20
1.48
1.81
1.81
2.06
2.06
2.39
2.39
2.39
MN1641