Dodge HXT305A Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} Dodge HXT305A. Dodge HXT305A 9 pagina's. For hydroil, torque-arm speed reducers taper bushed for char-lynn h, s, t and 2000 series 6b spline motors

Pagina afdrukken

Again turn output hub to roll in the bearings. With a

feeler or taper gage, measure the gap between the

housing and the carrier, clockwise from and next to

each screw. To determine the required shim

thickness, take the average of the two feeler gage

readings. Remove carrier and install the required

shims. Note: Total shim thickness per carrier

should not include more than .009" plastic shims

and each plastic shim should be inserted between

two metal shims. Place a

Dow Corning RTV732 sealant on the face around

the I.D. of the end shim (sealant is to be between

reducer housing and shim) and install carrier on

reducer housing. Torque carrier bolts to value

shown in Table 7. Output hub should have an axial

end play of .001" to .003".

7. Using the same procedure as in step 6, adjust the

input shaft bearings, except the axial end play

should be .002" to .004".

Table 7 — Bolt Tightening Torque Values

Reducer

Housing Bolts

Size

(in.-lbs.)

HXT305A

HXT405A

HXT505A

" diameter bead of

Seal Carrier Bolts

(in.-lbs.)

600

204

600

360

900

360

8. Apply sealant to the input shaft cover gasket and

install input shaft cover in right-hand housing half.

Install input and output seals. Extreme care should

be used when installing seals to avoid damage due

to contact with sharp edges on the input shaft or

output hub. This danger of damage and consequent

oil leakage can be decreased by covering all sharp

edges with tape or paper prior to seal installation. Fill

cavity between seal lips with grease. Seals should be

pressed or tapped with a soft hammer evenly into

place in the carrier applying pressure only on the

outer edge of the seals. A slight oil leakage at the

seals may be evident during initial running in but

should disappear unless seals have been damaged.

9. Install bushing back-up plate and snap rings.