Dodge FLEXIDYNE 75C Gebruiksaanwijzing - Pagina 8
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Dodge FLEXIDYNE 75C. Dodge FLEXIDYNE 75C 8 pagina's. Couplings and drives
Pagina afdrukken
Symptom
Vibration
Erratic Acceleration
Flexidyne Mechanism Doesn't Slip
Excessive Slippage
Poor or short flow charge life
1. Red oxide color, granular consistency
2. Red oxide color, powdery consistency, possibly with
powdery flakes
3. Black, powdery
4. Red oxide, powdery and chunky
5. Clumping of flow charge
P.O. Box 2400, Fort Smith, AR 72902-2400 U.S.A., Ph: (1) 479.646.4711, Fax (1) 479.648.5792, International Fax (1) 479.648.5895
© Baldor Electric Company
MN4034
(Replaces 499868)
Flexidyne Mechanism Trouble Analysis
Cause
1. Misalignment
2. Bent shaft
3. Excess flow charge
4. Fused flow charge
5. Improper installation – Output shaft
jammed against housing
1. Breakdown of flow charge
2. Caked flow charge
3. Below minimum amount of flow
charge
1. Improper installation – Output shaft
jammed against housing
2. Flow charge in bearings – causing
bearing seizure
1. Not enough flow charge
2. Overload
3. Worn flow charge
4. Worn rotor
1. Excessive slip at start up
2. Excessive inching or jogging of
machine
Flexidyne Mechanism Flow Charge Analysis
Condition
6040 Ponders Court, Greenville, SC 29615-4617 U.S.A., Ph: (1) 864.297.4800, Fax: (1) 864.281.2433
*4034-1011*
1. Normal after some usage.
2. Worn-out, can cause Flexidyne mechanism damage.
3. Rotor worn, excessive slip and heat.
4. Worn-out and moisture present.
5. Moisture present, use stainless flow charge.
World Headquarters
Dodge Product Support
www.baldor.com
Cure
1. Realign drive or coupling.
2. Replace or straighten.
3. Remove small amount of flow charge.
4. Correct the overload.
5. Readjust spacing between shafts and
Flexidyne housing.
1. Replace flow charge.
2. Moist environment – use stainless flow
charge.
3. Add flow charge.
1. Readjust spacing between shafts and
Flexidyne housing.
2. Replace seals, bearings and
flow charge or replace Flexidyne
mechanism.
1. Add flow charge.
2. Relieve overload
3. Replace flow charge.
4. Replace rotor.
1. Add flow charge to reduce starting
time.
2. Install time delay in motor control
circuit.
Cause
All Rights Reserved. Printed in USA.
10/11 Printshop 300