Clippasafe 130 Gebruiksaanwijzing - Pagina 3

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Clippasafe 130. Clippasafe 130 5 pagina's. Extendable swing shut gate

5. The gap between the gate and the wall (x) should be no less than 12mm and no more

than 60mm. The two vertical supports should be at 90° to the horizontal bottom bar.

6. If the gate is too high for the latch, the spindle next to the latch should be screwed

further into the frame, while the spindle on the opposite side should be unscrewed from

the frame.

If the gate is too low for the latch, the spindle next to the latch should be unscrewed from

the frame and the spindle on the opposite side should be screwed further into the frame.

Finally tighten all of the nuts with the spanner.

7. To block the opening

direction of the gate, open

one of the small catches,

located on the underside

of the latch mechanism,

on the side which you

want to block.

When fitting the gate at

the top of a stairway,

always block the opening

towards the stairs, so that

the gate opens away from

the stairs.

Using the Gate

Before using the gate ensure that it is fitted correctly aand is secure.

To open the gate, slide the latch (1)

towards the wall and lift the gate (2).

The gate should open both ways unless

one opening way is blocked as shown above.

When correctly fitted, the gate will swing shut from the open position. The gate can be

closed manually by holding the handle and closing the gate door until it locks into position.

Always check that the gate is closed and locked before leaving unattended.