DOEPFER Dark Energy III Aanvullende technische informatie - Pagina 4

Blader online of download pdf Aanvullende technische informatie voor {categorie_naam} DOEPFER Dark Energy III. DOEPFER Dark Energy III 6 pagina's.

Pagina afdrukken

To establish other connections than the ex works defaults suitable cables can be used (so called jumper wires or

Dupont wires or Raspberry Pi wires or similar). These are available from electronic shops or Amazon. It is important

to order the female-female version of the cables (not male-female or male-male).

JP13...JP17

are just

soldering

point in question. Instead of this pin headers with one pin can be assembled to JP13...JP17. In this case the female-

female cables mentioned above can be used too.

Example: when the JP6 jumper is removed socket #8 can be used for other functions: wiring the left pin of JP8 to

JP14 e.g. turns socket #8 into LFO1 rectangle output instead of LFO2 reset input.

Of course the front panel printing is then no longer valid and a suitable label should be used to indicate the new

function of the socket.

Function of the trimming potentiometers (Dark Energy III Voice Board):

Name Function

P17

VCO Scale

P18

VCO Offset

P19

VCO Octave Switch +

P20

VCO Octave Switch -

P21

VCF Scale

P22

VCF Offset

DARK ENERGY III - Additional Technical Information – Page 4

points. If applicable the wire in question has to be soldered directly to the soldering

Explanation

adjusts the 1V/octave characteristics of the

socket "VCO F" or the bus CV

adjusts the VCO frequency offset

adjusts the upper position of the VCO range

switch (+ 1 octave)

adjusts the lower position of the VCO range

switch (- 1 octave)

adjusts the 1V/octave characteristics of the

socket "VCF F" or bus CV (if the tracking

switch is in the lower position "full")

adjusts the VCF frequency offset

Factory default

adjusted to 1.00V/octave

64 Hz @ center position of the VCO Tune

control and Range switch in center

position

adjusted to +1 octave

adjusted to -1 octave

adjusted to 1V/octave, VCF in self-

oscillation (Resonance control fully CW)

~ 10 Hz @ CCW position of the VCF Frq.

control, VCF in self-oscillation (Resonance

control fully CW, all VCF modulations off)