DOEPFER LMK2+/USB Gebruikershandleiding - Pagina 2

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DOEPFER LMK2+/USB. DOEPFER LMK2+/USB 12 pagina's. Midi master keyboard usb version

Pagina afdrukken
INDEX
1
2
Midi Connection
3
USB Connection
4
5
6
OPERATING AND SECURITY INSTRUCTIONS
7
7.1
7.2
7.3
APPENDIX A: Information about the velocity response curves
APPENDIX B: Pin assignement of the jack sockets
APPENDIX C: Velocity reduction factor for the black keys
APPENDIX D: Information about the 16 factory presets
Important Note: Initialization of the unit
To initialize the unit (i.e. to re-establish the factory settings) one has to operate the buttons 1,2,7 and 8
(PRESET + PRG/REAL T. + CONTR. + PANIC) simultaneously during power on. Then all LEDs light up eight
times. The unit has to be turned off and on again. The devices should remain about 10 seconds in the off state
before it's turned on again. After that the user preset has the same values as from the factory. The values are
the same as for the fixed factory preset #2, i.e. entire keyboard Midi channel 1, all controllers active, wheel 1 is
assigned to Midi-controller #1 (modulation). One may use the initialization if the user preset is totally mis-
adjusted. In this case it may be easier to initialize the whole unit than to readjust each single parameter. If the
keyboard for example does no longer output Midi note messages the split zone parameters lower/upper key are
probably misadjusted - e.g. lower = upper key, i.e. the zone is one single key only
LMK2+/USB User's Guide
LMK2+/USB User's Guide Page 2