Dog Care WELL-D SD EC11 Snelstarthandleiding - Pagina 2

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Dog Care WELL-D SD EC11. Dog Care WELL-D SD EC11 5 pagina's. Dog training collar

Dog Care WELL-D SD EC11 Snelstarthandleiding
a. If no signal (beep, vibration or shock) is sent to the Receiver/Collar within 6-8 hours, it
will go into Sleep Mode (the collar will turn OFF). To use the units again, make sure to
turn them ON.
b. This is designed to save power, but also to remind owners to check the prong's contact
with their dog's skin.
6. How to "Pair" the receiver (collar) with the remote.
The remote and receiver have been paired at the factory. Channel Display is "1". (The
a.
EC-11 supports a maximum of 3 receivers).
i. To start, the collar should be turned OFF. Press the ON/OFF button on the top
of the collar for 3 to 5 seconds. The indicator will not flash when it is off.
(When On it flashes green about every 5 seconds).
ii. The remote should be ON. Twist the knob at the top left of the remote
clockwise.
iii. Hold the ON/OFF button on the collar for about 5 seconds until the light
alternately flashes green and red.
iv. Then push the small orange pairing button on the back of the remote for about
5 seconds. When it pairs the receiver (collar) will beep and will go back to
flashing green at a normal speed.
v. You can test by pressing the beep or vibration buttons.
7. To Pair Additional Collars to the Remote. (EC-11 can pair up to 3 collars on 1 remote).
i. The collar should be turned OFF. Press the ON/OFF button on the top of the
collar for 3 to 5 seconds. The indicator will not flash when it is off.
ii. The remote should be ON. Twist the knob at the top left of the remote
clockwise.
iii. Toggle the channel switching button and select channel 2 or 3. The display will
show the channel number.
iv. Hold the ON/OFF button on the collar for about 5 seconds until the light
alternately flashes green and red.
v. Then push the small orange pairing button on the back of the remote for about
5 seconds. When it pairs the receiver (collar) will beep and will go back to
flashing green at a normal speed.
vi. You can test by pressing the beep or vibration buttons.
8. What does the security key lock function do?
a. The security lock button is located on the left side of the remote. It locks or unlocks the
remote. In the locked position it will prevent the remote from working and from shocking
your dog if a button on the front of the remote is accidentally pushed.
9. How do I test the shock?
a. Make sure the receiver and remote are charged.
b. Adjust the static/shock level to about 10. (You should feel something at this level, but it
won't be too powerful).
c. Press and hold the static level regulator button (Level) on the remote while simultaneously
rotating the knob on the top left to the desired strength.