Dogtra 2700T&B Gebruikershandleiding - Pagina 14

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Dogtra 2700T&B. Dogtra 2700T&B 19 pagina's. 1-dog system only training & beeper collar

Pagina afdrukken

13. Using the Test Light

1. To turn on the receiver/collar, place the red dot on the

back of the transmitter to the red dot on the receiver/

collar. Hold the two red dots together for a moment

until the LED light on the receiver/collar comes on.

The indicator light will come on for a moment then

blink once every 4 seconds, showing that the collar is

ready to use (the receiver needs to be charged if the

indicator light is red). The receiver/collar will emit a

melody when turned on.

2. Turn the transmitter on by pressing the black button

on the right side of the transmitter until the LCD

screen illuminates. The LED will blink every 4 seconds

and the LCD screen will show the remaining battery

life (the transmitter needs to be charged if there is

only 1 bar showing on the battery icon for the LCD

transmitter screen).

3. Place the test light, included in the package contents,

on the contact points as shown in the diagram.

4. Watch the test light as you push the Nick button on

the transmitter. It should light up for just a moment.

The higher the intensity, the brighter the test light will

be.

5. Watch the test light as you push the Constant button

on the transmitter. It should light up as long as the

button is pressed. However, as a safety feature, the

receiver/collar will automatically stop the stimulation

if the Constant button is pressed for 12 seconds or

longer.

6. Turn the Rheostat Dial on the transmitter clockwise

and then counterclockwise. The test light should glow

brighter with higher levels of stimulation and dimmer

with lower levels. When you change the intensity dial,

the number on the LCD screen will change as well.

Note: The test light may not be visible if the intensity

level is set below level ten.

7. To make sure that your beeper is working properly,

press the Locate button once with the horn portion

facing away from you (or place your hand over

the horn). The sound may be extremely loud and

may cause discomfort to your ears. If you do hear

an audible beeper sound, your Locate button is in

working order.

8. Press the Mode button once; you should hear 2 rapid

beeps. This will put you into the Run/Point mode.

Keep the receiver/collar steady to mimic your dog at

a standstill point. Wait for a moment until you hear a

double beep every 2 seconds. You may proceed to the

next step if the double beep occurs.