DogWatch Hidden Fence System Gebruikershandleiding - Pagina 6
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} DogWatch Hidden Fence System. DogWatch Hidden Fence System 15 pagina's.
Ook voor DogWatch Hidden Fence System: Gebruikershandleiding (14 pagina's)
Pagina afdrukken
SYSTEM
3000
RECEIVER PROGRAMMING
Custom Response: When you combine the Transmitter rate and the Receiver Training
Levels, you can customize the Receiver to one of 13 training settings, as outlined in the
chart below:
Training Level
—
1
(Low)
2
(Medium)
3
(Med High)
Transmitter
T
slow? low
slow? medium
slow I high
Rate Settings
~
medium I low
medium / medium
medium / high
~
fast! low
fast? medium
fast? high
Training Level
4
(High)
5
(X-High)
Audible Only
Transmitter
7
X-fast I high
fast I X-high
slow? audible
Rate Settings
2
X-fast I high
fast? X-high
medium I audible
1!
X-fast? high
fast? X-high
high ? audible
'Level 4 Will not release a stronger correction Than the Medium High setting
it will just ~ it at a faster rate.
When the Training Level is set to 4 (High) or 5 (Extra High) on the Receiver, it will override The Transmitter
Rate Setting and remain constant.
Setting The TransmItter: The Transmitter rate switch adjusts to three settings:
(1
—
slow, 2— medium, 3
—
fast). When your dog gets an electrical correction, he receives
it in a series of pulses per second. Increasing the rate means that he will receive a greater
number of pulses per second.
SettIng The Receiver: The System 3000 Receiver provides six training levels that
allow you to customize the training setting to your dog's individual needs:
low, medium, medium high, high, extra-high, and audible only. When the Receiver is
first turned on, it will automatically be set to Training Level 2 (Medium).
To change the setting of the Receiver, hold your test light magnet between the two
raised lines on the side of the receiver
(see Figure A on Page 4).
Hold the magnet steady
and you will hear a series of beeps as the Training Level advances. From Level 2
(Medium), the Training Level will continue to advance as long as the magnet is held
in position, beginning with three beeps (Training Level 3 (Medium High). The beeps
(or Receiver Tones) represent the Training Level you are at, as follows:
When you reach your desired Training Level setting, pull the magnet away from the
Receiver. The Receiver is now set. Note: Any time the magnet activates the Receiver,
it will advance the Receiver setting to the next Training Level, and continue to cycle
through the settings in the order shown on page 6.
Recommended Settings
The majority of dogs respond well to Transmitter Rate Setting 2 and a Receiver
Training Level 2 (Medium). Sensitive dogs that train easily respond best to lower rate
settings and lower training levels. If your dog is a little more resistant to training, adjust
your system to a higher rate setting and training level.
If Your Dog Is Hard To Train
Training Levels 4 (High) and 5 (Extra High) of your System 3000 are specifically designed
to meet the needs of hard to train or problem dogs. These setting will provide that little
extra correction that some dogs need as part of their training.
As with all DogWatch products, all settings are designed to be Pet FriendlyTM and will not
hurt your dog in any way. When the Training Level is set to 4 (High) or 5 (Extra High) on
the Receiver, it will override the Transmitter rate setting and remain constant.
Exclusive Training Options
When your dog is first introduced to the DogWatch system as part of a supervised training
session, you might find it helpful to start with the Audible Only setting. The correction fea
ture is now off and your dog will only hear the warning beep as he approaches the fence
boundaries. The Audible Only Training Level Receiver setting is independent of the
Transmitter mode setting.
Multiple Dogs
System 3000 allows you to select Audible Only as your training level setting on each indi
vidual Receiver
—
allowing you to conduct training with one dog while the other is still pro
tected with the correction feature enabled. It is recommended that the Audible Only set
ting be used only during supervised training sessions.
TRAINING LEVEL
RECEIVER TONES
Medium High
3 Beeps
High
4 Beeps
Extra-High
5 Beeps
Audible Only
1 Long Beep
Low
1 Beep
Medium
(reset level)
2 Beeps
cycle will reset
4