ASG DTT-10 Bedieningshandleiding - Pagina 4

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} ASG DTT-10. ASG DTT-10 12 pagina's.

To use place the unit on a smooth, flat, level surface. Clamp the unit using the

optional calibration / mounting bracket if higher torques are to be used.

To attach the bracket, remove the screws holding the 4 rubber feet found on each

corner of the unit. The back plate is held in place by 2 more mounting screws. DO

NOT REMOVE THESE SCREWS, OR REMOVE THE BACK PLATE OR THE

WARRANRY IS VOIDED. The bracket may be mounted with the clamping knobs at

the top of the unit, or at the bottom of the unit. Replace the screws and rubber feet to

retain the bracket. Do not over tighten and distort the rubber feet.

CAUTION DTT-500 and later versions of the DTT-200 have a built in mounting

bracket. Firmly bolt the DTT-200 and the DTT-500 to a level surface such as a

bench or wall bracket to prevent injury.

Select the proper torque units. The unit will default to lbf.in when you turn it on. You

can use the "UNIT" button to scroll through the available units until you find the one

you want. If the unit "wakes up" reading units other than lbf.in that can be changed in

the system menu

If the unit is not at 0 press the "RESET / ESC" button. The unit will default to the PEAK

setting when turned on. Use the "MODE" button to change to the TRACK or FIRST

PEAK setting if desired. This function may not work with the battery charger connected

to the unit.

OPERATION OF THE DTT METER WITH THE FACTORY DEFAULTS

The meter comes from the factory ready for normal operations. The POWER SWITCH,

BATTERY CHARGER CONNECTOR, and RS-232 SOCKET are on the left side of the

meter. The SERIAL NUMBER is on the back of the meter.

During normal operation, the LCD display will show: The Measurement Mode in the

upper left-hand corner of the LCD. The Measurement Units in the upper right hand

corner of the LCD. The Torque Reading in the center of the LCD, The Current Time in

the lower left hand corner of the LCD and the circle (or CW / CCW arrow) showing the

direction the torque was applied. These items are in Bold type in the display below.

This will be referred to as the operating display.

Consult the programming and calibration manual for optional features which can be

enabled. When any of those features are enabled there will be indications on the LCD

To alert you that they are enabled.

There are 4 buttons located on the front of the meter near the bottom. The buttons

perform various tasks depending on whether the meter is set to do normal operations

or if you are programming the meter.