Cynosure, Inc. RadioLASE 3 Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Cynosure, Inc. RadioLASE 3. Cynosure, Inc. RadioLASE 3 20 pagina's.

2.1.3

Flammable Environment

2.1.3.1 Some materials, for example cotton, wool, and gauze when saturated with oxygen may

be ignited by sparks produced in normal use of the equipment.

2.1.3.2 Do not use the Generator in the presence of flammable anesthetics or other flammable

gases, flammable liquids, or flammable objects.

2.1.3.3 Do not use this device in oxygen enriched atmospheres or in the presence of nitrous

oxide (N 2 0).

2.1.3.4 Use only non-flammable agents for cleaning.

2.1.3.5 Flammable agents used as solvents for removing adhesives should be allowed to

evaporate before powering on the Generator. Any flammable fluid pooled under the

patient or in the body depressions should be mopped up prior to using

the Generator. Attention should be called to the danger of ignition of endogenous gases.

NOTE: To ensure safe and reliable operation, the Radiolase

accessories should be checked for wear and tear before operation.

A maintenance contract with the manufacturer or one of its authorized service agents is

recommended after the warranty period.

3.0

SUPPLIER'S INFORMATION

Cynosure, Inc. dba Ellman

400 Karin Lane

Hicksville, New York 11801 U.S.A.

(516) 594-3333 • (800) 835-5355

Supplier will make the following available upon request; circuit diagrams, component parts list,

description, calibration instructions or other information necessary to assist technical personnel.

ATTENTION: Alcohol must never be used to clean and disinfect the front panel.

3.2

CLEANING, DISINFECTING AND STERILIZING THE UNIT AND ACCESSORIES

3.2.1

Use only nonflammable and nonexplosive agents. No moisture or detergents should

enter the unit.

3.2.2

Handpiece and Electrodes.

Always clean and disinfect the electrodes prior to sterilization.

Disinfect and sterilize handpieces and electrodes according to the directions supplied

with them.

All autoclavable products should be routinely inspected for any wear, breaks, or

deterioration of the insulation, and should be discarded and replaced if any of these

occurrences exist.

3.2.3

The footswitch is a waterproof unit; it can be cleaned with regular detergent.

3 Generator unit and relevant