ASG DTT-L 5 Gebruikershandleiding - Pagina 9

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ASG DTT-L 5. ASG DTT-L 5 15 pagina's. Digital torque testers

Basic Function (Continued)

Zeroing the Tester

While operating the tester, it may be necessary to zero the display so that residual torque does not become part of the measured
reading. Press and release the ZERO key.

Changing the Unit of Measure

You can choose from the following units of measure depending on the capacity of your tester: N.mm (not available on the DTT-L 500),
N.cm, N.m, kgf.cm, kgf.m, lbf.in, and lbf.ft. To change the display units, press the UNIT key. Each time the UNIT key is pressed, it will
select the next available unit until the tester returns to its original setting. The DTT-L automatically converts readings as new units of
measure are selected.
NOTE: All units may not be displayed depending on tester capacity.

Changing the Mode of Measure

You can choose from the following modes of measure: Track, First Peak, and Peak. To change the display mode, press the MODE
key. Each time the MODE key is pressed, it will select the next available mode until the tester returns to its original setting.
ASG, Division of Jergens, Inc.
S. Waterloo Road | Cleveland, OH
15700
DTT-L Series Digital Torque Testers
User Manual
Track Mode
Press the MODE key until "Track" appears on
the display. The display will now indicate the
torque applied in either direction as it is applied
to the transducer.
First Peak Mode
Press the MODE key until "FPeak" appears on
the display. The display will show the torque
level applied to the transducer.
Peak
Mode
Press the MODE key until "Peak" appears on
the display. The display will show the maximum
torque applied to the transducer during a cycle.
| Phone: (
44110-3898
888) 486-6163
| Fax: (
| Email: asginfo@asg-jergens.com | www.asg-jergens.com
216) 481-4519
Page 9 of 15