Acquaer TRP010-2 Gebruikershandleiding - Pagina 5

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Acquaer TRP010-2. Acquaer TRP010-2 13 pagina's. Transfer pump

Pagina afdrukken

Attach the pump (A) to a sturdy base (table, board, etc.) to prevent it from tipping over. Make sure the

hoses are as straight as possible.

WARNING: This pump CANNOT be submersed in water, and the motor

CANNOT get wet at all. Getting the motor wet could cause

electrocution, which could lead to serious injury or death!

NOTICE: DO NOT coil or kink the hose

To operate, plug the pump (A) into a GFCI outlet.

NOTICE: This pump can be very loud when plugged in. THIS

IS NORMAL. Once water begins to pump, the noise will

dissipate. When the water level has been reduced to

approximately 1/8 in., you MUST UNPLUG THE PUMP. DO

NOT RUN DRY. The pump will be EXTREMELY LOUD when

the pump is no longer pumping water.

NOTICE: If water is not pumped in 30 seconds, unplug the

power cord and check the connection on the two ends of the

inlet hose to make sure there are no air leaks. Then, add

water into the inlet again and repeat the process.

Problem

1. Blown fuse

2. Tripped breaker

Pump does

3. Plug disconnected

not start or

4. Corroded plug

run

5. Motor overheated

1. Air leak in suction line

2. Impeller clogged

Pump doesn't

3. Impeller worn or damaged

prime

4. Impeller dry

1. Hose kinked or coiled

2. Strainer or hose blocked

Flow rate is

3. Discharge hose too long

too low

4. Worn impeller

PREPARATION

TROUBLESHOOTING

Possible Cause

Corrective Action

1. Replace fuse

2. Reset breaker

3. Secure plug

4. Clean plug prongs

5. Unplug the power and wait for 30

minutes,then plug in the power cord

1. Repair suction line by tightening

hose connection

2. Remove blockage

3. Replace impeller

4. Add water to the pump inlet

1. Straighten hose

2. Clean strainer or hose

3. Shorten the hose (50 ft. max)

4. Replace the impeller