Ashcroft T7 series Installatie- en onderhoudshandleiding - Pagina 5
Blader online of download pdf Installatie- en onderhoudshandleiding voor {categorie_naam} Ashcroft T7 series. Ashcroft T7 series 19 pagina's. Pressure, differential pressure and temperature switch
Pagina afdrukkenFor each use scenario, the corresponding set-up regulations must be respected. If used in explosion risk areas, the
following conditions are to be respected for the individual finishes.
2.2 Operator's responsibility
Safety instructions for proper operation of the device must be respected. They are to be provided by the operator for
use by the respective personnel for installation, servicing, inspection and operation. Risks from electrical energy and
from the released energy of the medium, from escaping media and from improper connection of the device must be
eliminated. The details for this are to be found in the corresponding applicable set of regulations, such as DIN EN,
UVV (accident prevention regulations) and in sector-specific instances of use (DVWG, Ex-. GL, etc.) the VDE
guidelines and the regulations supplied by local utilities companies.
The device must be taken out of service and secured against inadvertently being restarted, if the presumption is that
risk-free operation is no longer possible (see Chapter 10: Faults).
Conversion works or other technical alterations to the device by the customer are not permitted. This also applies to
installation of spare parts. Possible conversations or alterations may only be carried out by the manufacturer.
The operational safety of the device is only guaranteed where it is used for its intended purpose. The specification of
the device must be adapted to the medium used in the plant. The limit values indicated in the technical data must not
be exceeded.
The safety information detailed in this Operating Manual, existing national regulations for accident prevention, and the
operator's internal regulations regarding working, operations and safety must be respected.
The operator is responsible for all specified servicing, inspection and installation works being carried out by authorized
and qualified specialists.
2.3 Staff qualifications (target group assessment)
The device may only be installed and started up by specialist staff who are familiar with installation, start-up and
operation of the product.
Specialist staff are people who are able to assess the work assigned to them on the basis of their specialist training,
their knowledge and experience and their knowledge of the relevant standards, and can identify possible risks.
For devices in explosion-protected configuration, these staff must have been trained or instructed in, or be authorized
for, working on explosion-protected devices in potentially explosive plants.
2.4 Signs/Safety markings
The switch and its surrounding packaging carry markings. These markings show the article number, measurement
range and manufacturer. The switches can be provided with additional signs and safety markings advising on special
conditions:
Advice on calibration
Ex (for ATEX configuration)
2.5 Safety equipment
This device is fitted with safety locking devices and electrical earthing. The detecting element, when filled, secures the
operating rod preventing removal and contains two venting holes that ensure that the interior of the enclosure is not
subject to pressure greater than 2 lb/ft².
2.6 Environmental protection
This device contains electrical components. The provisions set out in the WEEE regulation EU directive 2002/96/EC
on electrical and electronically equipment are to be respected, and the products are registered at the EAR under the
number DE 26646349.
Page 5 of 19