CYP PUV-1510RXWP Bedieningshandleiding - Pagina 10
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} CYP PUV-1510RXWP. CYP PUV-1510RXWP 20 pagina's. Hdmi over cat5e/6/7 wallplate transmitter with 48v poh
Pagina afdrukken
6.3 Receiver Front Panel
1
POWER: This LED will illuminate when the device is receiving power
via PoE (Power over Ethernet).
2
LINK: This LED will illuminate solid when both Transmitter and
Receiver are connected and communicating with each other properly.
3
LAN: Connect to an Ethernet device or to your local network as
appropriate.
4
RS232 OUT: Connect (via D-Sub 9-pin female cable) to the device that
is to be controlled by RS-232 commands.
5
HDMI OUT: Connect to an HDMI equipped display such as an HDTV or
projector for display of the HDMI input source signal.
6
IR IN 1: Connect to the supplied IR Extender cable for IR signal
reception. Ensure that remote being used is within the direct line-of-
sight of the IR Extender.
7
IR OUT 2: Connect to the supplied IR Blaster cable for IR signal
transmission. Place the IR Blaster in direct line-of-sight of the
equipment to be controlled.
8
UPDATE: This switch is reserved for factory use only.
10
2
1
POWER
LINK
UPDATE
IR
OUT 2
IN 1
8
7
6
LAN
RS232 OUT
HDMI OUT
PUV-1510RXWP
5
3
4