CYP CDPS-UA1H10HS Bedieningshandleiding - Pagina 8

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} CYP CDPS-UA1H10HS. CYP CDPS-UA1H10HS 12 pagina's. 1 by 10 hdmi splitter with hdcp 2.2
Ook voor CYP CDPS-UA1H10HS: Bedieningshandleiding (12 pagina's)

Pagina afdrukken
CYP CDPS-UA1H10HS Bedieningshandleiding

6.2 Rear Panel

HDMI IN
1
2
1
1
HDMI IN: Connect to HDMI equipped source equipment such as a
Blu-ray player, games console, Set-top Box or any HDMI equipped
source device.
2
HDMI OUT 1~10: Connect to HDMI TVs/displays or AV receiver for
output of video and/or audio.
3
SERVICE: This slot is reserved for firmware update use only.
4
SYS. RESET ON/OFF: Set this switch to the ON position will allow the
device to reset the output image with the source every 10 minutes.
It will force the connected TV/display to switch to the HDMI port
that the device is connected to ensure the correct input is always
displayed. The reset will be performed sequentially from 1~10 with
1 minute a port. The default setting is OFF, leave as it is to disable
the reset function.
Note: TV/monitor must have CEC compatibility for this feature to
function properly.
5
EDID STD/TV: Use this switch to set HDMI EDID's setting.
TV: When in 'TV' mode, the unit will read the EDID settings of the
display device connected to HDMI OUT 1. If it detects a 4K×2K
capable EDID setting it will transmit the signal in that format to all
outputs. If no 4K×2K capable EDID is detected then the unit will
output the best resolution that all displays can support.
NOTE: When Output 1 is connected to a 4Kx2K display and Outputs
2–4 are connected to non-4K displays no picture may be displayed.
To ensure proper display all screens must all be capable of
displaying the same resolution.
STD: When in 'STD' mode, the unit will use its own built-in EDID
settings. In this mode, the video output will be set to 1080p@60Hz
and the audio output at LPCM 2CH Stereo. Use this mode if there
are display problems in TV Mode.
6
DC 5V: Connect the adaptor included in the package and
connect to AC wall outlet for power supply.
3
HDMI OUT
3
4
5
6
2
7
8
9
10
SERVICE
DC 5V
SYS.RESET
EDID
ON OFF
STD TV
3 4 5
6