CYP QU-18WE Bedieningshandleiding - Pagina 5

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} CYP QU-18WE. CYP QU-18WE 9 pagina's. V1.3 hdmi 1 to 8 mountable splitter

1. 2CH/Multi CH – Support 2 channels or Multi audio channels audio function This

selection is only available when EDID is in STD mode.

Note:

When Multi CH is selected TV/ display must also support Multi CH function

otherwise, TV/display will have no audio output unless, HDMI output connect

to AVR and then to TV/display. 8/12 bit – Supports 8 or 12 bit's deep colour

function. This selection is only available when EDID is in STD mode.

Note:

When both 8 bit and 12 bit displays are connected to the HDMI output , switch

the unit to 8 bit using the selector switch to ensure all screens display a signal.

On the other hand, if all screens are 12 bit or all 8 bit then switch the selector

switch to 12 bit or 8 bit to ensure the correct output is displayed. The splitter

cannot output 8 bit and 12 bit simultaneously, so the lesser bitrate must be

selected to ensure the displays operate correctly.

2. Sys. Reset: System reset function. It is suggest having this function switch OFF

always except when doing system reset. By switching to ON the system will

reset HDMI output to HDMI 1 within 8~10 minutes, switching to OFF means CEC

bypass.

Note:

The system reset function only functioning when the display has built-in CEC

functionality.

3. Power & LED: Power switch On/Off Red LED illuminate when power is on.

4. HDMI INPUT: Connect your source equipment with HDMI cables. 3

Page 3