Dolmar 111 Servicehandleiding - Pagina 9

Blader online of download pdf Servicehandleiding voor {categorie_naam} Dolmar 111. Dolmar 111 19 pagina's.

DOLMAR GmbH

04 Ignition system

04-04 Removing the ignition armature and

the flywheel

For the removal of the ignition armature

unscrew the cover (07-01) and the starting

assembly (1).

04-04 Installing the ignition armature

Install the ignition armature and secure in

place using screws (3). For setting the air gap,

fit gauge (5), no. 944 500 890, between fly-

wheel and armature. Turn the N/S marking of

the flywheel towards the ignition armature.

04-04 Withdrawing the flywheel

Unscrew nut (9). Screw the punch (10),

944 500 880, on the crankshaft and remove

the flywheel by striking a jarring blow.

04-04 Removing ignition armature/flywheel

Withdraw short-circuiting cable (2) from the

armature and unscrew screws (3). When

replacing, remove ignition cable from the

ignition armature (4). Screw new ignition cable

forcefully into the ignition armature.

04-04 Replacing the short-circuiting cable

For the removal of the short-circuiting cable

(2) it is necessary to remove carburettor (7)

and bottom part (8). When installing the cable,

ensure that it is not caught when fitting the

bottom part.

04-04 Installing the flywheel

Ensure that the cone on the flywheel and on

the crankshaft is free from grease.

Tighten the nut using a torque of 25 Nm (refer

to table 995 709 180).