Ashly PROTEA SYSTEM II 4.24C Bedieningshandleiding - Pagina 15
Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Ashly PROTEA SYSTEM II 4.24C. Ashly PROTEA SYSTEM II 4.24C 20 pagina's. 24 bit digital crossover and system processor
Ook voor Ashly PROTEA SYSTEM II 4.24C: Technische opmerkingen en specificaties (2 pagina's)
Operating Manual - PROTEA SYSTEM II 4.24C Crossover / System Processor
7. TROUBLESHOOTING
7.1 - Audio Troubleshooting Tips
No power - Is the detachable AC cord fully plugged in? Is the rear panel power switch on?
Controls don't work - check the Security Level. If set to Full Lockout, then Protea unit is "view only".
Change security settings in Util menu.
No sound - Check to see if the input or output is muted. Is the input or output Gain turned down? Check the
selected audio source(s) for each output, making sure there is signal applied to the designated input(s). If the cross-
over is used, make sure the high pass filter (HPF) is set to a lower frequency than the low pass filter (LPF).
Clip light stays on - Is the input signal level too high? Check to see that the nominal input level is 0dBu,
allowing 20dB of input headroom. Are input or output gain settings too high? Check to see if an EQ filter has too
much boost.
Distorted sound but no Clip LED- Check individual EQ filters to see if there is excessive boost.
Muffled sound - If expecting full range audio on an output, make sure the crossover settings are not inadvert-
ently set so as to limit the pass band.
Excessive Noise - An input signal level or an input gain setting that is too low could require the loss to be
made up for at the output gain stage, producing more noise than a properly set up gain structure. Do not use the 4.24C
for dramatic increases in level, but rather optimize the signal source for a nominal 0dBu output.
Forgot the password - See section 4.7e
7.2 RS-232/MIDI Troubleshooting Tips
1. Test all data cables. Use standard MIDI cables and RS232 data cables with all conductors wired straight
through. Monitor cables and Null Modem cables use non-standard wiring schemes, they will not work with a Protea.
See section 5.2 and 5.3 if using custom wiring.
2. Use a valid PC serial port. You must use a serial port that is not opened to any other application, such as a
mouse, modem, or another program. To verify that the port exists look in: Control Panel - System - Device Manager
- Ports. While you're there, make sure that the port has no warnings or conflicts. There is no need to change the port
settings because Protea System Software will do this automatically. Finally, you must select the valid port in Protea
System Software. This is done under the Communications heading - Com Port Assignment.
3. Make sure that the RS-232 mode switch, located on the back of 4.24C, is in the "out" position. There is just
one exception to this rule: the RS-232 mode switch gets pushed in only when both the RS232 Dataport is connected to
a PC, and the 4.24C is part of several Protea products in a MIDI chain.
4. Make sure the MIDI channel selected within the 4.24C (Util menu) matches the MIDI channel chosen for
the crossover section of Protea System Software, and make sure that no other devices use that MIDI channel.
15