Ashly CLX-52 Bedieningshandleiding - Pagina 7

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} Ashly CLX-52. Ashly CLX-52 12 pagina's. Compressor/limiter
Ook voor Ashly CLX-52: Technische opmerkingen en specificaties (2 pagina's), Bedieningshandleiding (12 pagina's), Technische opmerkingen en specificaties (2 pagina's)

Pagina afdrukken

Operator Manual – CLX-52 Compressor/Limiter

CLX-52 Rear Panel

Inputs and Outputs - Your CLX

Compressor/Limiter is provided with three

different connector types. 1/4" TRS (tip-ring-

sleeve) jacks, XLR connectors and Euroblocks.

Inputs are 20K active balanced using 1%

metal film resistors, outputs are 132 servo-

balanced.

Use four screws and washers when rack mounting the unit. For mobile use, the unit should

be further secured as appropriate.

General Requirements

The CLX-52 has specific physical, electrical and signal requirements for proper operation.

These requirements will vary depending on your specific application, setup, and the

settings on the unit. When setting up and testing your system, please take special care to

double check all connections and settings. Please refer to the specifications section of this

manual for specific input, output and other figures.

AC Power

Your CLX-52 equalizer should be connected to a standard 3-wire grounded electrical

outlet supplying 100-240 Volts, 50-60 Hz. To reduce the risk of ground loop hum, connect

all audio equipment to the same electrical power source. Removal of the ground pin is both

unlawful and dangerous, as a potential shock hazard could result.

This unit will perform normally within the AC voltage range specified above. Voltages

less than this, as found in "brown-out" conditions, may reduce performance. In the event of

a blown fuse, replace only with same type fuse. No user serviceable parts are inside the

chassis. Overall power consumption is less than 5 watts.

NOTE: The power switch does NOT isolate the appliance from mains. Make sure the mains

power socket or an alternative disconnect device is near by and easily accessible. When the

product is connected to mains, the line-filter and the input of the fuse are energized.

Detector Loop – Ducking - The CLX

Compressor/Limiters have a TRS Insert

DETECTOR PATCH point which can be used

as a "ducking" input, or in conjunction with an

equalizer to produce frequency-sensitive

limiting. Various uses of the detector patch are

discussed under Typical Applications.

Power – Switches the unit power on or off.

Page - 7

Safety Instructions – 3

Introduction - 4

CLX-52 – 5

Connectors & Cables – 5

Physical Description - 6

Front Panel

Rear Panel

Installation – 7

General Requirements

AC Power

Typical Applications - 8

Troubleshooting - 9

Dimensions - 9

Specifications - 10

Warranty - 11