Cypress Communications 1140 Snelstarthandleiding

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cypress Communications 1140. Cypress Communications 1140 2 pagina's.

Using a Bluetooth wireless headset

Your IP Phone 1140 is equipped with a radio system to support Bluetooth wireless–enabled technology enabled

headsets. This document describes how to configure your phone to work with a Bluetooth headset and how to use

Bluetooth and wired headsets interchangeably.

Configuring your phone to work with a Bluetooth headset is called "pairing".

Tip: Do not pair more than one headset of the same model, they have identical names in the Paired list.

Pairing a wireless headset with your phone

1. Double-press the Headset key rapidly to open the Bluetooth Setup dialog box. The Enable Bluetooth check box

is highlighted. If the Bluetooth Setup menu fails to open when you double-press the Headset key, the Bluetooth

wireless feature is not enabled. Contact your system administrator.

2. Press the Enter key (middle of silver Navigation button) to activate Bluetooth wireless technology. A check

appears to indicate that the feature is activated. The message "Bluetooth Enabled" appears at the bottom of the

display.

3. Put your Bluetooth headset in its pairing or search mode. The procedure for doing this can be different for each

headset; please refer to the documentation that accompanied your headset for more information.

4. Search devices.

a. Ensure that your headset is in Pairing or Search Mode.

b. Highlight the Search button, displayed next to the Search Devices item.

c. Press the Enter key. The message "Searching...." appears. It can take up to two minutes for the search to

complete. If the search is successful, the message "Search Completed Found Device(s)" appears, and the

name of your Bluetooth device will appear in the "Found" box. If the search is not successful, the message

"Search Completed. No device found" appears. If this happens, or if the headset times out and exits

search/pairing mode, power off the headset, and repeat Search Mode steps.

5. When the name of your headset appears in the Found: box and the message "Choose device and press Pair"

appears.

Note: If your headset is not displayed in the Found: box check you headset documentation to make sure it is in

pairing mode and repeat step 4.

6. Your Bluetooth device should not be highlighted in the Found box. Press the Pair button soft key (next to the

Search item) and press the Enter key.

At the prompt "Enter PIN#", enter the PIN using the phone dial pad and press the OK key. If pairing is successful,

the message "Pair completed" displays.

Tip: Check your headset documentation to find its PIN (sometimes called a passkey). Typically this value is 0000.

If the headset is not successfully paired with your phone, an error message appears at the bottom of the screen.

If an error message appears:

•

Confirm that the wireless headset is still in search/pair mode. If the headset timed out and exited

search/pairing mode, put the headset in pairing mode, as discussed in step 3, and repeat step 6.

•

Check that you are using the correct PIN. Repeat step 6.

Press the Use Softkey

•

Press the Exit Softkey

7. To make your Bluetooth Device the active device follow these steps

Double-press the Services rapidly key twice

•