Dolphin PXH822 Handmatig - Pagina 8

Blader online of download pdf Handmatig voor {categorie_naam} Dolphin PXH822. Dolphin PXH822 18 pagina's. Pci express adapter

Pagina afdrukken

Installation

Step 1 - Unpack board

The PXH822 card is shipped in an anti-static bag to prevent static electricity damage. The card should only be removed from the
bag after ensuring that anti-static precautions are taken. Static electricity from your clothes or work environment can
damage your PCI Express adapter card or your PC. Always wear a grounded anti-static wrist strap while opening the
PC and when the PXH822 is removed from the anti-static bag.
Unpack the PXH822 from the anti-static bag using proper anti-static procedures.

Step 2 - Configure the Board for Proper Operation

The PXH832 has one bank of 8 DIP switches. The default factory setting for the PXH822 is Transparent mode, short cable, single (up
to x16) link connection. The PXH822 has DIP switches for setting special modes or operations. Please carefully read the
documentation before modifying any DIP switch settings. Please pay close attention to ON and OFF positions written on the DIP
switch.
DIP Switch Bank – Configuration
Figure 2: DIP Switch shows the DIP switch for the PXH822. It is used to configure the
adapter card. Please leave all undocumented DIP switches in the default position. Table
1: DIP Switch settings shows all the various DIP switch settings for the PXH822. The
table below lists all options and DIP switch settings for the card
DIP no.
Description
1
Configuration selector, details next
page Step 2 - Configure the Board
for Proper Operation
2
Enable Target or Host operation.
3
Configuration selector, details next
page
4
Enable long-cable configuration.
Please use same setting on both
Host and Target
5
For future use
6
CMI Disable
7
Holds the management processors
in reset
8
Enables the card to boot if the
EEPROM has been corrupted
Note: Some DIP switch configuration options may be changed in the future versions. Please always consult the latest
user guide for details. This document covers firmware version 8.10.
PXH822 User's Guide – Dolphin Interconnect Solutions
ON
OFF
Adapter is configured for
Adapter is configured for
transparent Target
transparent Host
operations
operations
Support cables of 4m
Supports cables of 0.4-3m
length and longer or
length
fiber optic cable
Will DISABLE CMI
CMI is supported if a PCIe
3.0 cable is installed
Board management is
Normal operation
held in reset
Safe EEPROM
Normal operation
Table 1: DIP Switch settings
Figure 2: DIP Switch
Default
ON
OFF
OFF
OFF
OFF
OFF
OFF
OFF
Page 8