Cyrus Cyrus Quattro Gebruiksaanwijzing - Pagina 6

Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Cyrus Cyrus Quattro. Cyrus Cyrus Quattro 7 pagina's. Hi-fi products

Pagina afdrukken
Cyrus Quattro
Connection and Operation of the Quattro as a
CD/Tuner Source
The Quattro may be supplied or converted to provide the functions of a high
quality CD and Tuner source (when optional tuner module is fitted) in a Cyrus
system. When this conversion has been made, the legend 'Pre-amp' will no
longer appear as an installed option on the display when the Quattro is
connected to the AC power.
Connecting the CD output to the amplifier
Connect the CD Direct Outputs c from the Quattro to the CD input of the
amplifier.
Connecting the tuner output to the amplifier
If a tuner module is fitted, the output signal will be routed through the Tape
Output of the Quattro. Connect the Tape Outputs d from the Quattro to the
Tuner input of the amplifier.
MC-Bus connection
The Quattro may be connected into an MC-Bus loop with other Cyrus
products to enable remote system power control from the main amplifier.
Refer to the amplifier instructions for an MC-Bus wiring diagram.
Front panel operation
The front panel keys for controlling CD and tuner functions will still operate,
but there will be no response from the keys for Input Source Selection or
Volume Control (these functions will be available from the system amplifier).
Remote Control Operation
A Cyrus System remote control, such as the Audio Commander (supplied with
Cyrus amplifiers) will control all system functions for the Quattro and other
components.
Note: The remote control supplied with the Quattro will no longer operate the
unit.
CD Dir
Quattro
MC-BUS
Cyrus 7
4
TAPE OUT
MC-BUS
TU in
CD in

TROUBLESHOOTING GUIDE

If your Cyrus Quattro is not operating properly, disconnect the power and
check all connections using the notes in this handbook. If problems persist,
the checklist below may help.
If you are in any doubt, consult your dealer.
Switch off the power to the audio system and check that connections have
been correctly made from the Cyrus Quattro to the power amplifier.
Disc Spinning with no sound from the speakers
Power amplifier not switched on.
Headphones connected to the rear
panel socket.
Pause may have been set. Check for
the pause symbol on the display.
Skipping tracks or distorted sound
The disc may be dirty or badly
scratched.
Indication 'Disc error' on the display
The disc will not read.
Unable to select FM radio
Tuner module not fitted.
No radio stations can be found/poor quality radio sound
Signal strength inadequate.
No Remote Operation
The handset batteries may need to
be replaced:
Display reads 'WRONG R'MOTE'.
The batteries in the remote control unit should only be replaced with
new batteries type AA (I.E.C.L R06).
User Instructions
Switch on amplifier
Disconnect headphones
Press the PLAY/PAUSE key again
on the front panel or handset to
cancel pause.
Try playing another disc. If the other
disc plays ok, try cleaning the 1
disc.
It may be dirty or defective.
Arrange for a better aerial.
Remove the battery compartment
cover located underneath the unit.
Remove the batteries and replace
with new ones carefully noting the
orientation marked in the bottom of
the battery case.
The Quattro has been converted to
operate as a CD/Tuner. The Audio
Commander
remote
control
(supplied with Cyrus amplifiers) must
be used after this conversion.
GB
GB
st