Cytech UCM/Modbus Snelstarthandleiding

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cytech UCM/Modbus. Cytech UCM/Modbus 4 pagina's.

The UCM/Modbus allows Modbus devices to be interfaced to Cytech's Comfort

system. The UCM/Modbus can be programmed either as a Modbus Master or Slave.

Master mode is for Comfort to control other Modbus Slave products, and Slave

mode is for a Modbus Master to control Comfort, eg software. Both modes are

capable of 2- way communications, ie Comfort to Modbus and Modbus to Comfort,

Modbus/RTU (RS485 or RS232) and Modbus/TCP are possible by plugging in the

RS485, Rs232 or ETH03 Ethernet submodule onto the UCM/Modbus baseboard.

The UCM/Modbus can work with other Comfort modules including Intelligent

Remote Input/Output Modules (IRIO), MSM01 Multisensor Module, Hotel I/O (HIO)

as well as 3

party systems on the Comfort Bus including C-Bus allowing Modbus to

be integrated with other 3

Specifications

Modbus Master or Slave Mode

•

Physical Interfaces Modbus/RTU (for RS485) using RS485 submodule and

•

Modbus/TCP using ETH03 submodule.

Comfort (CM9001), UCM/Logic, LGX01 Logic Engine can act as the central controller

•

for UCM/Modbus.

For Master Mode: 256 Modbus addresses in Modbus to Comfort.

•

IDs can be specified for each Modbus Address

For Modbus Slave, supported Function codes are; Read Discrete Inputs, Read Coils,

•

Read Input Registers, Read Holding Registers, Write Single Coil, Write Single Holding

UCM/Modbus Quick Start Guide

party products.

INTRODUCTION

Different Modbus