Cytech MN-GSM Snelstarthandleiding - Pagina 7

Blader online of download pdf Snelstarthandleiding voor {categorie_naam} Cytech MN-GSM. Cytech MN-GSM 9 pagina's.

Setup

UCM/4G - UCM Baseboard with GSM submodule

Insert a Nano SIM card into the SIM card holder by pushing the top edge with

•

the slanted corner facing inwards. The SIM card must not be password

protected. Disable password protection if applicable.

Connect the antenna, and connect J3 on the UCM/4G to J54 (GSM) on CM9001

•

via the 5-way cable provided.

Before connecting the power to UCM/4G from Comfort, the ID on SW7 must be

•

set according to Table 1, i.e. the ID has to be set according to the number of

UCMs in the system. If there is only 1 UCM, the ID on the UCM/4G must be set

to 2. By convention, ID 1 is reserved for writing and reading from Comfort, and

is not reported in case of Communications Failure. Comfort supports a

combination of 8 UCMs.

The UCM/4G power is connected to Comfort via the supplied 4 way white cable

•

from the 4 pin header JP2 Comfort II's RS485 header. This supplies power to the

UCM/4G, as well as allowing communications between Comfort and the UCM/4G.

It is not necessary to switch off the power to Comfort before plugging in this

connection.

The RDY LED (green) should be turned on, indicating that the UCM firmware is

•

running. The BUSY1 LED will be on while the UCM/4G is establishing the GSM

network connection.

UCM/4G Quick Start Guide