EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft Handmatig - Pagina 15
Blader online of download pdf Handmatig voor {categorie_naam} EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft. EG Aircraft MX2 50CC Giant Scale Aerobatic Aircraft 19 pagina's.
Pagina afdrukken3. Use your radio to set the servo center position and install the large control horn onto the servo.
Assemble the control rod and ball links and adjust the control linkage for proper geometry. When
satisfied, screw the ball link to the servo arm. The servo arm should be as close to perpendicular to the
control rod as possible while the elevator is at neutral. Double check all screws, bolts and nuts to assure
proper installation and operation without binding.
4. To install the horizontal stabilizers you first need to install two 30" servo wire extensions in the
fuselage so that they extend from the radio compartment to the aft openings. A servo wire tunnel is
provided in the fuselage to guide the wires.
5. Slide the stabilizer carbon fiber tube into the fuselage and install both stabs onto the tube. Connect the
servo wires and secure the connections with either the supplied clips, tape, or likewise. Use the supplied
screws and rubber washers to secure the stabilizers to the fuselage.
W ING AND AILERON CONTROLS ASSEMBLY:
U U
U U
1. Install the fiberglass control horns in a similar fashion as described above. Again, make sure they are
properly aligned to each other and fully seated in their respective slots.
2. Cut the covering from the aileron servo openings from corner to corner and iron down inside the
openings. Connect servo wire extensions to your servos and secure the connections with the supplied
clips, your own clips, or tape. Feed the servo wires into the wing and out the root. Install the servos and
screw firmly in place.