BlueRange UNO9BLACK/SP Gebruikershandleiding - Pagina 3
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} BlueRange UNO9BLACK/SP. BlueRange UNO9BLACK/SP 8 pagina's. Solar powered auto darkening welding helmet
Pagina afdrukkenWARNING
The auto -darkening welding helmet is not suitable for laser welding or Oxyacetylene welding.
Never place the helmet and auto -darkening filter on a hot surface.
Never open or tamper with the auto -darkening filter.
The auto -darkening welding helmet will not protect against severe impact hazards.
The helmet will not protect against explosive devices or corrosive liquids.
Do not make any modifications to either the filter or helmet, unless specified in this manual.
Do not use replacement parts other than those specified in this manual.
Unauthorised modification and replacement parts will void the warranty and expose the
operator to the risk of personal injury.
Should the helmet not darken upon striking an arc, stop welding immediately and contact your
supervisor or your dealer.
Do not immerse the filter in water.
Do not use any solvents on the filter's screen or helmet components.
Use only at temperature: -5°C --+55°C.
Storing temperature: -20°C -+70°C.
Keep filter away from liquid and dirt.
Clean the filter's surfaces regularly, do not use strong cleaning solutions. Always keep sensors
and solar cells clean by using a clean, lint -free tissue/cloth.
Regularly replace the cracked/scratched/pitted front cover lens.
Severe personal injury could occur if the user fails to follow
the aforementioned warnings, and/or operating instruction.
See spare parts list on back cover.
T ROUBLESHOOT ING
Irregular Darkening Dimming
Headband has been set incorrectly and there is an uneven distance from the eyes to the filter's
lens. (Reset headband to reduce the difference to filter.)
Auto -darkening Filter Does Not Darken Or Flickers
Turn the sensitivity knob to "HI" position
Front cover lens is soiled or damaged (change the cover lens)
Sensors are soiled (clean the sensors' surfaces)
Welding current is too low.
Slow Response
Operating temperature is too low (do not use at temperature below -5°C)
Poor Vision
Front/inside cover lens and/or filter lens are soiled (change lens)
There is insufficient ambient light.
Shade number is incorrectly set (reset the shade number).
The protective film of the front/back cover lens has not been peeled off.
Welding Helmet Slips
Headband is not adjusted properly (readjust headband)
Operator must stop using the auto -darkening welding helmet immediately if the problems
Warning:
mentioned above cannot be corrected. Contact the dealer.
BLUERANGE
Page 3