Egardia Key pad Installatiehandleiding - Pagina 3
Blader online of download pdf Installatiehandleiding voor {categorie_naam} Egardia Key pad. Egardia Key pad 4 pagina's.
Pagina afdrukken
Before mounting the key pad
remove the plastic battery tab at
the back of the key pad to
activate the battery. The
indicator lights of the key pad
will now flash a few times.
INSTALLING THE KEY PAD
The installation process of the Egardia key pad consists of four easy steps.
STEP 1.
CHECK CONTENTS
STEP 2.
ADD TO ALARM SYSTEM
STEP 3.
MOUNT KEY PAD
STEP 4.
CHECK AND TEST
STEP 1: CHECK CONTENTS
Check the contents of the packaging for the following parts:
1.
Key pad (battery is factory installed in the key pad)
2.
Bag containing screws and plugs
3.
Velcro tapes for mounting
STEP 2: ADD TO ALARM SYSTEM
You are now about to register the key pad with your Egardia alarm system.
1.
Remove the plastic battery tab at the back of the key pad to activate the battery. Ensure the
tab has been completely removed! The green indicator light will glow and the red indicator light
will flash 5 times. Wait till both indicator lights extinguish.
2.
Ensure at your gateway that the alarm is turned off. The top indicator light (Status) and the
bottom indicator light (Online) are lit green.
3.
Press the "Reset" button at the side of the gateway for at least 5 seconds. The top indicator
light (Status) of your gateway flashes green to indicate it is searching for new accessories.
*
4.
Press the asterisk key (
) and the hash key (#) simultaneously for at least 3 seconds. The
gateway beeps once to indicate the key pad is successfully registered. The gateway beeps
twice to indicate the key pad has already been successfully registered.
5.
Press again the "Reset" button at the side of the gateway for at least 5 seconds if no more
accessories are being added. The gateway returns to normal operation.
6.
Login to your Egardia account and go to the tab "Alarm system". The registered key pad will
appear after a few minutes.
7.
Rename the key pad for easy recognition.
STEP 3: MOUNT KEY PAD
Place the key pad close to the door normally used to enter and leave the property. Before mounting
use the key fob to test the desired mounting place is within range of the gateway.
Important guidelines
Place the key pad close to the main front or back door to easily operate the Egardia alarm
system when leaving or entering the building.
Place the key pad where it is not visible from outside.
Mount the key pad at a comfortable height but out of reach for small children.
2
CHECK THE CONTENTS OF THE BOX
REGISTER THE KEY FOB WITH YOUR
EGARDIA ALARM SYSTEM
DETERMINE THE LOCATION AND
MOUNT THE KEY PAD
CHECK AND TEST THE KEY PAD