d&b audiotechnik Ti10 Handmatig - Pagina 4
Blader online of download pdf Handmatig voor {categorie_naam} d&b audiotechnik Ti10. d&b audiotechnik Ti10 10 pagina's.
Ook voor d&b audiotechnik Ti10: Gebruikershandleiding (14 pagina's)
Pagina afdrukken
Fig. 1: Ti10 loudspeaker
Fig. 2: Ti10 Horn and lens
in line source setup
Fig. 3: Ti10 Horn and lens
in point source setup
Ti10 Manual
Ti10
The Ti10 is the installation version of the T10 loudspeaker. It is a very
compact loudspeaker system which can be used both as a line array and
as a high directivity point source speaker. For these applications the Ti10
cabinet provides two different dispersion characteristics which can be
swapped over without any tools.
The core of the design is a unique combination of a rotatable waveguide
with horn and an acoustic lens. The horn natively provides a vertical line
source with 90° horizontal dispersion. The lens is part of the front grill
and widens the HF dispersion in line array mode to 105°. When used
upright as a point source, the lens curves the wavefront of the line source
providing a 90° x 35° dispersion pattern.
The Ti10 is a two way design employing dual 6.5" drivers, a 1.4" exit
compression driver and a passive crossover network. The low drivers are
positioned in a dipolar arrangement providing an exceptional dispersion
control towards low frequencies. Its frequency response extends from
68 Hz to above 18 kHz.
The Ti10 enclosure is constructed from polyurethane integral hard foam
with an impact and weather resistant black paint finish. The cabinet shape
allows the system to be set up as a single unit in upright orientation or as
a line array in user defined vertical configurations. The front of the
loudspeaker cabinet is protected by a rigid metal grill in front of an
acoustically transparent foam.
Ti-Series rigging components and arrays
For line and point source applications the Ti10 loudspeaker is available in
two different cabinet versions which are acoustically identical:
- Ti10L: Line source version including line array rigging devices. It can
be used as a line array and as a stand-alone loudspeaker with both
horn orientations.
- Ti10P: Point source version without line array rigging devices. It can
be used as a stand-alone loudspeaker with both horn orientations.
For line array applications Ti10L cabinets are mechanically connected
using the rigging strands on both sides of the cabinet front and a central
strand at the rear of the cabinet. All necessary rigging components are
mounted to the cabinet and are folded or slide out when needed. Splay
angles between adjacent cabinets can be set in the range from 0° to
15°.
For point source applications both the Ti10L and Ti10P are fitted with six
threaded inserts to connect to different rigging accessories like Z5371 T
Flying bracket, Z5372 T Horizontal bracket, Z5354 E8/E12 Flying
adapter or Z5020/25 Flying adapter 02/03.
(1.1 en)
Page 4 of 10