BlueSky Mast 350G XL Series Snelle referentie - Pagina 2
Blader online of download pdf Snelle referentie voor {categorie_naam} BlueSky Mast 350G XL Series. BlueSky Mast 350G XL Series 10 pagina's.
Ook voor BlueSky Mast 350G XL Series: Snelle referentieblad (10 pagina's)
Pagina afdrukken
1
Stand the 350G XL Tripod up
and make sure the base plates
are flat on the ground.
6
Extend the two tripod legs
adjacent to the winch. DO NOT
extend the tilt leg at this time.
11
Release the cam lock on the
bottom of the tripod.
16
Push the tripod upright, extend
the tilt leg and tighten the red turn
knob.
Do Not Duplicate, Alter, or Copy without the Express Written Consent
of BlueSky Mast, Inc. Copyright 2019 Allendale LLC All Rights Reserved
Quick Reference Sheet - Primary Guying Only
2
Loosen the red turn knobs on the
cross links of each tripod leg to
extend the legs.
7
Locate the stake bag with
hammer and tripod stakes.
12
Insert the mounting pole until one
hole is showing below the cam
lock and Lock the Cam Lock.
17
Make sure the base plates on the
three tripod legs are flat on the
ground.
350G XL - Lift Series
DEPLOYMENT
3
One at a time, slowly push down
on the red turn knobs while pulling
the leg out to extend it.
8
At a slight angle, drive a stake into
the left hole on each of the two
extend tripod leg base plates.
13
Locate the Red Primary Guy Ring
in the guying bag.
18
Using the three bubble levels,
level the tripod by adjusting the
tripod legs one at a time.
Read Manual Before Use
Refer to detailed instructions in the
350G XL Lift Series Manual at all times
4
Push the cross links all the way
down and tighten the red turn
knobs to secure them.
9
DO NOT stake the holes on the
right side at this time.
14
Pull the pin out and slide it onto
the mounting pole. DO NOT
secure it at this time.
19
At a slight angle, drive stakes in
opposite directions into the re-
maining holes on the base plates.
5
Loosen the turn knobs on the two
tripod legs adjacent to the winch.
10
Locate the mounting pole. It's the
only pole without a gold insert.
15
Mount your equipment to the
mounting pole and secure all
cables using Velcro Straps.
20
Locate the Lift Base Plate.