D&R ClubMix Handmatig - Pagina 9

Blader online of download pdf Handmatig voor {categorie_naam} D&R ClubMix. D&R ClubMix 20 pagina's.

10.11 PUNCH SWITCHES

The punch switches control soft fet switches which silently mute one or two of the crossfader outputs, this

feature creates intermittent rhythmic effects needed in today's live d.j. performances.

10.12 POWER SUPPLY

The power supply, which is located in the master section, is a highly regulated circuit with a torroidal

transformer to minimize hum pickup.

The phantom power supply switch sets +48 volt on every microphone input , when the individual jumper

setting on the mic/line channels is set to receive the phantom voltage.

11.0 MASTER IN/OUTPUTS

Located on the back of the master module the master in/outs are quarter inch jack sockets and XLR type

connectors.

11.1 ZONE 1 OUTPUT

These outputs are ground compensated balanced which means that they behave like a balanced output but

without the doubling of output power related with servo balanced output amps.

The XLR type connector wiring is conform international standards, pin1 is ground, pin2 is hot, pin3 is cold.

11.2 ZONE 3 OUTPUTS

This output is an unbalanced output which is wired as follows pin1 is ground, pin2 is left signal, and pin 3 is the

right output signal.

11.3 SUBBASS OUTPUT

The Subbass output of the ClubMix is a +4dBu ground compensated balanced output which has a frequency

roll off above 150 Hz by a gentle 6 B per octave avoiding phasing errors.

The subbass output is directly fed from the Zone 1 output.

The Zone 1 output controls the level of the subbass output at the same time.

11.4 LIGHT OUTPUT

The transformer balanced light output has a level of +4dBu and is wired on a stereo jack plug with the

transformer winding between the tip and ring. It is important not to wire the ground of this jack to the light

equipment. By only wiring the tip and ring to the light equipment a separation of ground is guaranteed, which is

important for your safety.

11.5 TAPE OUTPUT

The tape outputs are derived just ahead of the master f aders and the inserts so the signal is unaffected by

adjustments of the master faders.

The tape output level is -10dBv with an impedance of 100 ohms.

This output can also be used to drive any other equipment necessary if there is a need for an extra output.

Clubmix manual page 9