Asko 12605 Gebruiksaanwijzing - Pagina 9
Blader online of download pdf Gebruiksaanwijzing voor {categorie_naam} Asko 12605. Asko 12605 13 pagina's.
Pagina afdrukken10. After washing:
Turn off the machine by turning
the thermostat knob to 0. This
turns off the power, and the
indicator lamp goes out.
NOTE!
Leave the inner door slightly ajar
after use to allow air to circulate
within the machine.
If the machine won't work
Problem
The door will not open.
The machine does not fill with water
when started.
The machine does not start when the
program knob is turned to the starting
position.
The machine will not spin.
A lot of foam in the final rinse water, or
water left in the machine after spinning
and pumping out.
Safety
The machine cannot be started if the inner door is open. The inner door
cannot be opened while the machine is running or if it has stopped with
water in. It is a good rule never to leave a switched-on machine unattended.
Safety catch
The machine has a safety catch which prevents child-
ren from turning the thermostat/main switch away from
the 0 position or increasing the temperature. As supp-
lied, the safety catch on the machine is disengaged.
To engage it:
• Press the button beneath the thermostat knob and
then release it.
To disengage the safety catch:
• Press the slot in the end of the button with a coin.
• Push and turn the button slightly in the same
direction as if screwing in a screw (clockwise).
Response
1. Check that the temperature knob is in a position of at least 30°C (then the
power supply is connected).
2. If the indicator lamp is not lit, there is no power supply. Check the plug and
fuses. The door cannot be opened normally if there is no power supply.
3. If the door cannot be opened in the normal manner, it can be opened as
follows:
• Remove the lower front panel.
• Unscrew the plastic ring and pull. Then the door opens.
• Replace the ring and the front panel.
If the door still cannot be opened in the normal way afterwards, call a
service engineer.
1. Is the water tap turned on?
2. Is the strainer in the inlet connection blocked? Unscrew the hose and
check. Remember to turn off the water supply first.
1. Is the door properly closed? Press it shut firmly – don't slam it.
2. Is the main On/Off switch turned on?
3. Check that the temperature knob shows a temperature higher than 30°C.
1. Is the pump or outlet hose blocked? Clean if necessary, as described on
page 8. If there is too much water left in the machine, the spinning will be
omitted.
2. Has the power supply failed? Check the plug and fuses.
3. Check that the
-button is not pressed in.
1. Is anything blocking the outlet hose? A button or a coin can do so. Make
sure that no part of the hose (including any hose extension) is less than 15
mm in diameter.
2. Is the pump blocked? Clean it as described on page 8.
3. Is the outlet hose kinked?
9