ambient power AP087 Gebruikershandleiding - Pagina 3

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} ambient power AP087. ambient power AP087 4 pagina's.

Pagina afdrukken

16th December 2020

Introduction

Thank you for purchasing your Lighting Controller. This is

a small board with an integrated full colour LED design

to provide a multitude of lighting eﬀects suitable for

integration into model displays and other miniature

applications requiring realistic lighting.

Connections

The board has four connections, with power leads

already ﬁtted to pins 1 and 2.

Pins three and four are used for setup. Push switches can

be temporarily ﬁtted to these pins between the pin input

and ground. Take care not to connect to +12V, the board

will be destroyed if this happens. Once the controller has

been conﬁgured, the switches can be removed, the

setting of the controller is retained in non-volatile

memory for subsequent use.

Power Requirements

The module requires 12V DC at around 25mA.

Conﬁguring The Module

Fit momentary push switches between

connection - and 1 and connection - and 2.

These are 'Button 1' and 'Button 2' respectively.

By pressing Button 1, the mode is selected (see Mode Reference Table in this document). The mode is conﬁrmed

by the colour of light ﬂashing as shown in the table. Press the button repeatedly to step through the modes.

For certain modes, the type of operation can be selected by pressing Button 2. A preview of the lighting function

will be seen immediately.

Storing In Memory

Simply leave the module in the displayed mode for 15 seconds and the mode will be automatically stored. This

is indicated by a colour cycle ﬂash. Removing the power resets to this previously stored mode, or Mode 0 can be

selected as shown in the reference table.

Resetting To Factory Default

Press and hold button 1 while switching on power. The board will reset to Mode 3 (Medium Warm Light). The

colour cycle ﬂash conﬁrms the board reset.

Ambient Power

Lighting Controller User Manual

Connection

Function

Notes

+12V DC

Square pad on board / red wire

Black wire

Button 1

Used for setup

Button 2

Used for setup

Page of

E&OE