Asko W8844XLW Installatie-instructies - Pagina 3

Blader online of download pdf Installatie-instructies voor {categorie_naam} Asko W8844XLW. Asko W8844XLW 4 pagina's.

INSTALLATION

GROUNDING INSTRUCTIONS

This appliance must be grounded. In the event of

malfunction or breakdown, grounding will reduce the risk

of electric shock by providing a path of least resistance

for electric current. This appliance is equipped with a

cord having an equipment-grounding conductor and

a grounding plug. The plug must be plugged into an

appropriate outlet that is properly installed and grounded

in accordance with all local codes and ordinances.

FREESTANDING INSTALLATION

The washer can be placed next to the dryer. It is

essential that the machine is leveled and the locknuts

are tightened to prevent excessive vibration during

spin cycles. Also be sure to leave a minimum of ½" of

space between the washer and the dryer. The height

adjustment for the washer is 33½" to 34½" (850 mm to

876 mm). Do not raise it higher than 34½" (876 mm).

WARNING

Improper connection of the equipment-grounding

conductor can result in a risk of electric shock. Check

with a qualiﬁ ed electrician or serviceman if you are

in doubt as to whether the appliance is properly

grounded.

Do not modify the plug provided with the appliance. If

it will not ﬁ t the outlet, have a proper outlet installed by

a qualiﬁ ed electrician.

STACKED INSTALLATION

ASKO washers should never be stacked on a counter or

a dryer. You can, however, stack an ASKO dryer on an

ASKO washer. Refer to your Dryer Use and Care Guide

for instructions on how to do this.

Customer Care Center, 1-800-898-1879, www.askona.com

BUILT-IN INSTALLATION

ASKO washers can be installed beneath a cabinet or

worktop with a height of 34" to 35" (863 to 889 mm) or

in a closet. There must be a gap of about ½" (12 mm) all

around the machine, including between the rear edge of

the machine's top panel and the back wall. The opening

width must be at least 24½" (622 mm). Space must

also be available for the ﬁ ll and drain hoses. See the

illustration below for measurements and positions. If the

washer is installed in a closet the door must be left open

while the washer is running.

If the drain outlet is higher than 24"(610 mm), the

connections will need to be recessed.