Ambient Technologies RCB Installatie- en bedieningsinstructies - Pagina 5
Blader online of download pdf Installatie- en bedieningsinstructies voor {categorie_naam} Ambient Technologies RCB. Ambient Technologies RCB 5 pagina's. Basic on/off remote control
Ook voor Ambient Technologies RCB: Installatie- en bedieningsinstructies (2 pagina's), Installatie- en bedieningsinstructies (2 pagina's)
Pagina afdrukken
5. Slide the button to RS (the center position), then press the ON button on the transmitter to turn the system
to ON. The main gas flame should ignite.
6. Press the OFF button on the transmitter to turn the system to OFF. The flame should extinguish (the pilot
light will remain on).
Symptom
1. LED light on
1. Low Battery
receiver blinking or
battery icon on LCD
on transmitter.
4. Appliance does not
1. Wiring / Electrical Connections
come on after pressing
ON on transmitter
2. Privacy (DIP) switch setting on transmitter
does not match receiver
3. Distance between the transmitter and receiver
is more than 30 feet
5. Receiver cannot
1. Receiver is installed in an enclosure
receive signal.
This warranty gives you specific legal rights and you may also have other rights that vary from
state to state or province to province. Answers to any questions regarding our limited warranty may be obtained by
writing our corporate offices.
Ambient Technologies warrants each new Ambient Technologies remote control against any defects that are due to
faulty material or workmanship to the original owner, for a period of five years after the original date of purchase.
This warranty and our liability does not apply to batteries, nor does it include damage to merchandise or the remote
control resulting from accident, alteration, neglect, misuse, improper installation or any other failure to follow
Ambient Technologies installation and operating instructions.
Ambient Technologies agrees to repair or replace at its option any Ambient Technologies remote control under
warranty provided it is returned postage prepaid to our warranty facility in a padded carton within the warranty
period, with proof of the original date of purchase and a brief description of the malfunction. This limited warranty
does not include the cost of removal or re-installation.
50D0035 Rev 1 July 2002
TROUBLESHOOTING
Causes
WARRANTY
Ambient Technologies
149 Cleveland Drive
Paris KY 40361
FOR TECHNICAL SUPPORT
CALL 800-398-6195
Page 5 of 5
Action
1. Replace batteries. Change
batteries every 6 months.
1. Slide the switch to ON, if
appliance comes ON, wiring is not
the causes.
2. If appliance does not come on,
check wiring connections.
1. Make sure the transmitter and
receiver has the same DIP switch
settings.
1. Make sure the operating distance
is less than 30 feet
1. Make sure the receiver is not
located inside an enclosure.
Ambient Technologies
Monessen Hearth Systems
A Division Of