Ambient Weather WR-333A Gebruikershandleiding - Pagina 13

Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Ambient Weather WR-333A. Ambient Weather WR-333A 19 pagina's. Emergency solar hand crank radio, flashlight with am/fm/noaa weather band, certified weather alert and smart phone/pda charger

Pagina afdrukken

2. Lift the rubber tab on the back of the WR-333A to expose the connectors, as shown in Figure

3. Plug the smart phone charging cable (Figure 3) into the WR-333A charge USB output (Figure

4 reference 19). Plug the appropriate tip into the smart phone's charging connector.

4. If the phone does not begin charging, disconnect the phone and begin cranking. When

charging a smart phone via the smart phone charger, it is important to turn the crank at least

two revolutions per second. After two minutes of cranking at two revolutions per minute, wait

two minutes to begin cranking again. This will extend the crank life.

NOTE: You may receive a charging compatibility error on your smart phone, but your device may

still charge and it will not harm your device.

CAUTION: Before charging, please refer to the user manual of the device you wish to charge to

make sure the charging current required does not exceed 1Amp (1,000 mA) of charging current.

Overloading the charge circuit may damage the WR-333A and void the warranty.

7.6 Low Battery Indication

When the battery voltage is less than 3.0V, the low battery indication will flash:

The radio will not operate in a low battery condition.

7.7 Audio Output / Head Phones

The WR-333A includes an audio output jack. This allows you to listen with headphones or connect

to an auxiliary input source, such as an amplifier.

CAUTION: Guard your ears against hearing damage. When listening with headphones, start at the

lowest volume and gradually increase until you can hear it comfortably and clearly.

Read this Important Information before Using Your Earbuds:



Avoid extended play at very high volume as it may impair your hearing.



If you experience ringing in your ears, reduce the volume or shut off the unit.



Keep the volume at a reasonable level even if your headset is an open-air

type designed to allow you to hear outside sounds. Please note that excessively high volume

may still block outside sounds.

7.8 Resetting the Unit

If the unit experiences a power surge or electric shock, it is possible that the internal micro-controller

may lock up and the unit will not respond to any commands from the panel controls. In this event, use

a straightened paper clip, toothpick or similar objects to press the RESET button located on the

back of the unit (see Figure 9). The reset operation clears the system memory to factory default, and

all of your previous settings will be erased.

CAUTION: Do not use a sharp or pointed object to press the reset button. It may damage the reset

switch inside the unit.

Version 2.6

Page 13