Ambient Weather WS-8365 Gebruikershandleiding - Pagina 10
Blader online of download pdf Gebruikershandleiding voor {categorie_naam} Ambient Weather WS-8365. Ambient Weather WS-8365 12 pagina's. Clearview projection alarm clock with indoor temperature and outdoor temperature
Pagina afdrukken
Indoor Temperature
Outdoor Temperature
6.2 Power Consumption
Clock: 3 x AA Alkaline batteries recommended.
Wireless Transmitter: 2 x AA Alkaline batteries recommended, LiIon e2 Energizer for cold
weather.
7. Troubleshooting Guide
If your question is not answered here, you can contact us as follows:
1. Email Support:
2. Technical Support: 480-346-3380 (M-F 8am to 4pm Arizona Time)
Problem
The wireless sensor communication has
been lost or is intermittent or will not sync
up.
The clock does not respond to commands.
The projection is fuzzy
The clock is dim when running on
batteries only.
Version 1.3
©Copyright 2016, Ambient LLC. All Rights Reserved.
32 to 140 °F
-4 to 140 °F alkaline
batteries
-40 to 140 °F LiIon e2
Energizer batteries
Solution
± 2 °F
± 2 °F
Make sure the transmitter is powered up and the
LED is flashing about once per minute. For cold
weather environments, install lithium batteries.
If the transmitter is not flashing, replace the
batteries.
Resync the console. Reference Section 5.8.
The maximum line of sight communication
range is 150'. Move the sensor closer to the
clock.
If the sensor assembly is too close (less than
5-10'), move the sensor away from the clock.
Make sure the remote sensors are not
transmitting through solid metal (acts as an RF
shield), or earth barrier (down a hill).
Move the clock away from electrical noise
generating devices, such as computers, TVs and
other wireless transmitters or receivers.
Move the remote sensor to a higher location.
Move the remote sensor to a closer location.
Radio Frequency (RF) Sensors cannot transmit
through metal barriers (example, aluminum
siding) or multiple, thick walls.
Press the reset button on the back of the clock
with an open ended paper clip or sharp tool.
Adjust the focus setting.
Replace the batteries in the clock.
0.1 °F
0.1 °F
Page 10