Ambifuego KALIDO 73 Installatie-, gebruikers- en onderhoudsinstructies - Pagina 3

Blader online of download pdf Installatie-, gebruikers- en onderhoudsinstructies voor {categorie_naam} Ambifuego KALIDO 73. Ambifuego KALIDO 73 15 pagina's. Convector gas fire

Pagina afdrukken
Important Notes – Please read before undertaking the installation
This is not a "Do it yourself" product and it must be installed by a competent
1.
person.
2.
The fire has a ceramic Fire-bed arrangement; this contains Refractory Ceramic Fibres,
which are man-made vitreous silicate fibres. Excessive exposure to these materials can
cause irritation to eyes, skin and respiratory organs. Hence we recommend that when
handling these materials the release of dust should be kept to a minimum. During
installation and servicing we recommend that a HEPA filtered vacuum be used to remove
any dust and soot in and around the fire. If any of the ceramic fire-bed components need
to be replaced we recommend that the removed parts be sealed in a heavy-duty
polythene bag, and be labelled as RCF waste. RCF not "Hazardous waste" and can be
disposed of at a licensed tipping site for the disposal of industrial waste.
The appliance incorporates a permanent pilot. This is located on the front of the burner,
and must not be adjusted by the installer. This system must not be put out of operation,
and if any parts require changing, only original manufacturer parts shall be used.
This appliance is designed to be used either Natural or LPG gas however, each
individual appliance is only capable of running off the type of gas specified at the time of
purchase. It is important to note that once a type of gas has been specified the fire
cannot run off any other type. The type of gas that your fire is capable of burning is stated
on the data information panel.
This appliance has been designed, tested and approved to meet standards in place for
product use, performance and safety. Installation of your appliance must comply with
current building regulations. It is therefore recommend that a registered gas installer be
employed for this task. The engineer will provide you with information about the safety
limits of the installation and should fix a notice plate in a place where it can be readily
seen.
This appliance is designed as a decorative heating device and consequently all body
parts become very hot in use. Except for the control knob and control access door, which
are designed to stay cool, all other parts are working surfaces and should not be
touched.
The front of this appliance does not give full protection for young children, the
elderly or infirm, extra protection should be considered for these conditions conforming
to BS 6539 or BS 6778. The appliance is not fitted with a functional integral guard. In
normal use, consideration should be given to the use of an additional guard, conforming
to the standard above
3.
The chimney must be swept before the appliance is fitted.
4.
The Installation Instructions must be adhered to without exception.
Before fitting this appliance, ensure that the following components are enclosed
a)
Gas Fired Convector complete with burner and controls.
b)
Installation, Servicing & Users Instructions
c)
1 Packet of ceramic fibre flakes
c)
Decorative frame and louvered bottom cover
such that access to the open flame is minimised
,
3