AMBILIFE L100 Bedieningshandleiding - Pagina 7

Blader online of download pdf Bedieningshandleiding voor {categorie_naam} AMBILIFE L100. AMBILIFE L100 16 pagina's. Photocatalytic air purifier

Button «On/Off»

Button «MODE I»

Button «MODE II»

Remote infrared sensor window/LED «Failure»

The device is able to completely clean the air from all types of contaminants, includ-

ing: viruses, bacteria, allergens, spores, mold and fungi, urban smog, car exhaust, dust,

and any other chemical, biological and aerosol contaminants. A unique model of the Photo-

catalytic air purifier «Ambilife» with the excitement of the UV catalyst LED module.

Connect the device to the power source (stick the plug of the device's power cord

into the socket). To transfer the device to «wait mode,» transfer the «0/1» switch (power

To put the device into working mode on the control panel, click «On/Off» (Figure 3,

p.b.), and the LED begins to constantly light up.

To switch modes, press the MODE I or MODE II buttons on the control panel (Figure

3, p. 6), while the LEDs are in the mode.

«MODE I» is the main mode with maximum air fan performance.

level (recommended at night).

To turn off the device you need:

- press the on/off button on the control panel (Figure 3, p.b)and put the device on

standby, while the LED will start to blink green light;

- transfer the power switch 7 (SET) (Figure 2, p.b) to «0»;

remove the power cord plug from the socket.

If the device malfunctions, the red LED «PROD» lights up on the control panel (Figure

3, p. 6) and the device is disconnected, while it is necessary to disconnect the device

from the network by button 6 (Figure 2, p. b), to transfer it to the position «0».

To restart the device you need:

- press button 6 (Figure 2, p. 6), put it in «I» position;

CONTROL PANEL

7. PREPARATION AND WORK

On/Off

MODE I

MODE II

LED «Failure»

Figure 3