AMBION FLAME EF2003 Installatie- en gebruikershandleiding - Pagina 7

Blader online of download pdf Installatie- en gebruikershandleiding voor {categorie_naam} AMBION FLAME EF2003. AMBION FLAME EF2003 9 pagina's. Electric fireplace with remote control

Pagina afdrukken

g) Use the bracket as table template and mark five drill positions on the wall. Make sure that these

holes are level. Observe the recommended fixing dimensions.

h) Put the bracket aside and drill holes with a depth of 35 mm using an 8 mm drill bit.

Clean the holes from dust and insert one plug in each hole. Make sure the edge is flush with the

surface.

j ) Hold the bracket in position and fix it with screws.

k) Attach the fixing angle to the bottom of the appliance using the short screws.

Carefully lift the appliance and hook it to the wall bracket (Fig.5). Do not let the appliance go

until you are sure it is safely engaged to the bracket.

m) Now mark the hole position for fixing the angle, see Fig.6. Carefully remove the appliance from

the bracket and drill holes with a depth of 35 mm using an 8 mm drill bit.

n) Clean the holes from dust and insert one plug in each hole. Make sure the edge is flush with the

surface.

o) Then lift up the appliance again, engage it to the bracket and finally fix the angle with screws.

Placing pebbles or Log

a) Bring down the front-panel (fig. 2)

b) Take pebbles or Log out from package and put on the plastic board even (fig. 7)

c) Put front-panel up (fig. 9)

Instructions for Use

The appliance can be operated either by the switches are located on the top right hand side of the fire

or by supplied remote control.

Manual Operation

a) The switches are located at the top right hand side of the fire.

b) Press once the

button to turn on the appliance. A red indicator light will appear to indicate that the

function is ON. Press the (9 button for 3 seconds will operate the Automatic Flame show function,

the flame colors will change at intervals of 10 seconds. Press once the 700W button for the low heat

setting: press twice to switch off the heat setting.

c) Press once the 1400W button for the high heat setting; press twice to switch off the heat setting.

Remote Operation

a) It takes some time for the receiver to respond to the transmitter. Do not PRESS the buttons more

than once within two seconds for correct operation.

b) Press once the button � on the remote control this turns

c) Press once the 700W button for the low heat settings; press twice to switch off the heat setting.

d) Press once the 1400W button for the high heat settings; press twice to switch off the heat setting.

e) Press the FLAME button to change the flame colors, green, blue, orange, red and 10 mixed colors for

your options.

the appliance and fire effect.