Flismaskin 1500 Instrukcja obsługi - Strona 4

Przeglądaj online lub pobierz pdf Instrukcja obsługi dla Rębaki/Rozdrabniacze Flismaskin 1500. Flismaskin 1500 20 stron. Wood shredder - chipper

GENERAL

. Intended use

The shredder is designed solely for shred-

ding/chipping all kinds of newly cut tree

branches of diameter up to 8.5 cm.

. Restrictions

You should not use the shredder for shred-

ding/chipping metal, stones, plastics. If you

are going to shred tree roots check that the diameter is less than

8.5 cm and remove all earth, sand and stones.

Before using the machine for the ﬁrst time, check the maximum en-

gine speed by screwing in/out the screw which controls the position

of the throttle lever so that it is positioned as in the diagram. (ﬁg. 3)

After the ﬁrst hour's use check that the bolts of the blades and

counter blade are ﬁrmly ﬁxed and that the gap between blades and

counter blade is 0.5mm (half a millimetre). Adjust in the slots if nec-

essary and ﬁx the bolts.(fig. 2a, 2b)

The shredder is a machine for shredding/chipping newly cut wood.

The rotor has 2 blades each with a 30 cm width and is powered by

a gasoline engine. Transmission is through two parallel drive

belts. The shredded wood or chips are discharged through the out-

put tube by the centrifugal force of the rotor. Because of the angle

of the blades and the positioning of the counter blade branches

are pulled inside the machine automatically and no feeder belt is

required. (ﬁg. 1)

8,5cm

Manual Shredder - chipper