AMC 3100a Podręcznik użytkownika - Strona 5
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Wzmacniacz AMC 3100a. AMC 3100a 12 stron.
Drukuj stronę
REAR PANEL CONNECTIONS
CD INPUT
The CD input is suitable for use with any CD
player. Connect your CD player to the amplifier
using the phono sockets marked "CD".
TUNER INPUT
The Tuner input is suitable for use with most
AM/FM tuners. Connect your tuner to the amplifier
using the phono sockets marked "TUNER".
VIDEO,LD INPUTS
These VIDEO/LD inputs are suitable for use with
the audio signal from a stereo VCR (or stereo
TV/Satellite/Cable receiver) or other line level
source. Using the phono/phono leads connect to
the "Audio Out" of the unit to these inputs.
Note: These are audio inputs only.
TAPEl,TAPE2 INPUT/OUTPUT
This input is suitable for use with most cassette,
reel to reel or video recorders.
Connect the "record" leads of your tape recorder
to the ohono sockets marked "TAPE OUT" on the
rear of your amplifier using phono/phono leads.
Connect the
"playback" leads of your tape
recorder to the phono sockets marked 'TAPE lN'
on the rear of your amplifier using phono/phono
PRE OUT /MAIN IN
Normally the preamplifier and power amplifier
sections of this unit are connected together via
factory-installed U-shaped metal jumpers that
bridge the PRE-OUT and MAIN-IN.jacks.
Check
to be sure that they are fully inserted into the
jacks and that nothing is touching them.
By switching OFF the power and removing the
can connect a signal
surround-sound
decoder or
an electronic crossover in the oath between
preamp and power amp. connect a cable from
PRE-OUT to the processor's input and a second
cable from the processois output to MAIN lN.
LOUDSPEAKERS
Your AMC amplifier is designed to drive loud-
soeakers wrth a nominal imoedance of 4-8 ohms.
metal jumpers, you
processor such as a
LOUDSPEAKER
CONNECTIONS
The loudspeaker output terminals will accept
4mm (banana) plugs, spade connectors, pin
connectors or bare wires.
Connect the negative side (usually black) of your
left hand loudspeaker lead to the black terminal of
the two terminals marked "L" on the rear of your
amplifier. The other side of your left hand speaker
lead (the positive side or red) should be
connected to the red terminal marked "L". Reoeat
this operation for the right hand loudspeaker.
Your AMC amplifier is capable of generating high
peak currents. so all connections must be
checked to avoid inadvertent short circuits and to
ensure a good clean contact.
UNDER NO CIRCUMSTANCES
SHOULD THE
OUTPUTS BE SHORTED TOGETHER,
Such action will damage output circuitry and is
not covered by guarantee.
AC LINE CORD
Plug the AC line cord into a nearby wall outlet that
provides the correct AC power line voltage, or into
an unswitched convenience outlet on anv AMC
products.
HEATSINK/VENTILATION
REQUIREM ENTS
The heat produced by your AMC amplifier dunng
normal operation is dissipated by an internal
finned heatsink. lt is perfectly normal for your
amplifier to becomes quite warm and to radiate
heat when in use, especially if it is run near full
power. However, if it becomes too hot to touch,
switch off at once and contact your dealer.
It is very important that there is adequate
ventilation for the whole of the amDlifier. Do not
place the unit on a rug or other soft surface that it
could sink into, obstructing the air inlets on its
underside, and take care not to obstruct the outlet
grille on the top cover.