Amcrest IP5M-F1180EW-V2 Podręcznik użytkownika - Strona 10
Przeglądaj online lub pobierz pdf Podręcznik użytkownika dla Kamera bezpieczeństwa Amcrest IP5M-F1180EW-V2. Amcrest IP5M-F1180EW-V2 20 stron. 5mp v2 ultrahd fisheye poe camera
Drukuj stronę2. Open the hatch to expose the microSD card/factory reset button.
3. Place a microSD card into the provided microSD card slot, gold pins down, and press to secure.
Note: To perform a factory reset on the camera, hold the WPS/Reset switch for 30 seconds allowing the device to
reset. The device will reboot and be reset to its original factory settings.
Basic Wiring Overview
On your device you will notice a pre-attached wire pigtail containing 5 wiring connections. These connections
contain a power adapter connection, an Ethernet connection, audio wires (I/O), and alarm wiring. This device
comes equipped with a built-in microphone as well as the capability to connect an external microphone using the
RCA (Audio In) dongle wire connection. For more information, please refer to the information below.
Power
Ethernet Port
AUDIO IN
AUDIO OUT
ALARM
Camera Access Setup
This section of the guide will provide the user with information on how to setup access to the camera through any
of the following methods.
The camera will require a basic 12V DC power adapter. This wire also has an optional
grounding (EARTH) wire for additional grounding of the unit.
This connection is used to transmit data from the router to the device via an Ethernet cable.
This connection allows for the connection of a single channel, external RCA microphone to be
utilized. Please note, the "Line In" option must be set via the web user interface for this to
function. For more information, please refer to section, "5.4.1.3.1 Switching Audio In Device
Connections"
This connection allows for the utilization of a single channel, RCA speaker.
This connection provides alarm in and alarm out features to an external alarm or security
system. The basic overview of these wires are as follows: 1Yellow: ALARM_IN1, 2Orange
ALARM_OUT1, 3Gray Alarm_GND (Ground)
10