ACR STOVES Woodpecker Stoves WP4 Podręcznik techniczny - Strona 11

Przeglądaj online lub pobierz pdf Podręcznik techniczny dla Piec na drewno ACR STOVES Woodpecker Stoves WP4. ACR STOVES Woodpecker Stoves WP4 18 stron.

Drukuj stronę

Refractory internal panels

During the normal operation of your ACR stove, the refractory panels will experience heating

and cooling. Sometimes minor hairline cracks can occur. All ACR stoves have a steel or cast

iron structure behind the panels and therefore even if the cracks get larger, the stove will still

operate safely.

It is advisable to replace the internal panels when:

• The cracks are greater than 3mm.

• The surface of the refractory panel has eroded more than 25% of it's original thickness, or

• When the panel starts to crumble and fall apart in chunks.

To prevent the issue from happening and prolong the life of your internal panels, the

homeowner should "burn in" the refractory panels in the new appliance by building small

kindling fires to begin with and then gradually working up to a larger fire. When adding more

fuel to the fire, caution should be used to prevent excessive mechanical damage to the

panels.

ACR Heat Products bears no responsibility for the loss or damage of any kind to the internal

panels during or after installation or during the normal operation of the appliance.

Use only replacement parts recommended by the manufacturer.

Woodpecker WP4 Refractory panels:

Woodpecker WP5Q-P/LS Refractory panels:

Woodpecker WP5 Refractory panels:

Woodpecker WP5 PLUS Refractory panels:

20 of 32

Commissioning Check List

Please tick boxes when each procedure is completed

Ensure that the serial number has been recorded on the

front of the manual for future use

Visual inspection of appliance and flue ensure that all

internal components are fitted correctly (these may have

shifted in transit)

Ensure the door seals are in good condition and that the

glass is secured correctly in the door (do not over tighten

the glass as this will prohibit its expansion and could

cause the glass to crack)

Test on flue including satisfactory smoke test: Record

flue draught reading

Spillage test preformed in accordance with available

guidance

Check socket joints and seals on the flue and

appliance

Instruct user on correct fuels and fuel storage

Ensure the customer is aware that fumes may be given

off during the first firings as the paint cures

Instruct user on essential maintenance in particular

annual maintenance of appliance and flue

Hand over user instructions & demonstrate operation

and all controls to the user

Ensure that a Notice Plate has been completed and fixed

in position

Ensure that an approved Carbon Monoxide alarm has

been fitted in correct location as per Building Regs Doc J

Installation Company:

Installation Engineers Name:

Pa/Wg

21 of 32